Question about Chevrolet Malibu

1 Answer

I have a 2009 malibu LT2 my front speakers cut out then go back on when they want to can it be a loose wire

I checked the fuses there fine i was thinking a loose wire?

Posted by Al SAV on


1 Answer


  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 or more questions within one hour.

  • Expert
  • 95 Answers

Yes that is posible that you have a a loose wire

Posted on Jan 09, 2015


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

We have a 2004 Venture. Ran fine yesterday. This morning absolutely no power. Battery and fuses check out fine. No wires look loose. Suggestions?

When you say the battery and fuses check out fine, do you have power at the fuses and the starter ? Do you have headlights ?

Sep 01, 2013 | Cars & Trucks

1 Answer

No spark on a 1998 Chevy venture

Hi orvil brad hear I would check the ing. fuses you have at least one and maby two in the inside cab fuse block, and also one or two in the engine bay fuse panel, there is also a relay located in the eng. bay panel, also you may check the ing. wire that goes to the coil system, This wire will have no 12volts until the ing. switch is turned on then it will show 12volts. It has a habit of coming loose at the coil sometimes. Good luck

Dec 30, 2017 | 1998 Chevrolet Venture

1 Answer

Mighty Max Brake Lights, Stereo & Clock all stopped working at the same time. Any suggestions?

you may have a bad ground, or a short in one of the wires. pull out the stereo.

Aug 19, 2012 | Mitsubishi Mighty Max Cars & Trucks

1 Answer

I replaced fuel pump and fuel filter but car still wont start. it will only crank if i keep putting starting fluid in it. what would be the problem?

bad fuel pump, loose wiring, blown fuse, or bad fuel pump relay. don't think just because a fuel pump is brand new out of the box it's good. i got an A/C delco fuel pump, installed it in the customers truck tried to start it .... nothing. checked all wiring, grounds, fuse, relay etc. everything was good. pulled the pump back out of the tank and wired it direct to a battery and it did nothing. got another pump installed worked just fine.

Dec 24, 2010 | Chevrolet Suburban 1500 Cars & Trucks

2 Answers

I have a 1999 Chrysler LHS, Power Windows

yep master switch panel is shot!

Jan 14, 2010 | 1999 Chrysler LHS

1 Answer

The low beams and brake lights on my 91 Volvo 240 SW won't work

Check the wire connections, also check that bulbs are tight. you may need a new brake switch located on the back of the brake pedal for the (rear lights) As to it all happening at once I have no guess sounds like a loose connection or a wire shorting due to warn wire coating.

Sep 14, 2009 | 1987 Volvo 240

1 Answer

All my lights at the front apart from one main beam are not working iv changed the bolbs still nothing checked the fuse box every think seems fine its for a peugeot 206 1.1 petrol x reg

Check the wiring for loose connections or bad wires etcthen tape them up check wiring for lights and coming off the lights. Good luck and be careful.

Apr 25, 2009 | 1991 Peugeot 405

1 Answer

Intermittent display of stats on information display unit in Maz3

Found instruction on removal of display unit and able to check for loose wiring, quite simple really, now waiting to purchse another unit. Note that previous solution in regard to swapping fuses did not work. Terry

Apr 05, 2009 | 2005 Mazda 3

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

110 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides