How to remove a steering column on a 95 Buick Lesabre and remove the steering column on a 92 Pontiac Bonneville to replace it with the on from the Lesabre

call or notify a bone/junk yard they have the cross reference charts for vehicle parts or try a gm dealer these are a few that are compatible 97-99 Pontiac Bonneville SE 6Cyl 3.8L 231CID VIN K Fit Note Engine VIN: K, Naturally Aspirated 97-99 Pontiac Bonneville SSE 6Cyl 3.8L 231CID VIN K Fit Note Engine VIN: K, Naturally Aspirated 98-99 Buick LeSabre ALL ALL 97 Buick LeSabre ALL ALL Fit Note With Harness Codes: HEN, HER 97-99 Oldsmobile 88 ALL ALL 97-99 Oldsmobile LSS ALL ALL Fit Note Engine VIN: K, Naturally Aspirated 97-98 Oldsmobile Regency ALL ALL

Here's a link to a new part. http://www.autozone.com/external-engine/harmonic-balancer/dorman-harmonic-balancer/buick/lesabre/1992/6-cylinders-l-3-8l-sfi-ohv/232360_172580_0 a 92 PONTIAC BONNEVILLE WILL WORK,ALSO ALL SAME GM MOTORS AS YOUR'S WILL WORK.

The video at the link should help.
Click here.

This sounds like that actual turn signal switch assembly. To replace it you must remove the steering wheel and disassemble the column a little. This takes some special tools and skill.

correct then remove screws for turn signal switch and compress the lock plate and remove that to access lock cylinder.

For 1994 Buick Lesabre 3.8L SFI OHV 6cyl the turn signal flasher is under the instrument panel to the left of the steering column brace. On the Bonneville, it may be on the left side on the shroud. The hazard flasher is under the instrument panel to the right of the steering column.

The turn signal flasher is installed in a clamp attached to the base of the steering column support inside the car. In all cases, replacement is made by unplugging the old unit and plugging in a new one.

Hope helped (remember rated and comment this).

the igntion cylinder and the VATS module are not the same
you will have to replace the igntion cylinder from the column you took out
the security codes are different
hope this helps

The security system has been activated call the dealer to getthe deatils on how to reset it, normally you pull the security fuse for 30 seconds to restet it. if that does not work call the dealer and they can help you.

3.8L--any GM that used it. Buick lesabre, pontiac bonneville, chevy lumina(some)...very common engine

Hi,

Try Check or replace the turn signal switch. It might have loose connections or its faulty.