2005 Nissan Maxima How do we change a brakelight

The Titan is the same vehicle here in USA so follow the link.
Third Brake Light Bulb Change Nissan Titan 2004 2014 2007 Nissan Titan SE...

Hi
Our technical assistants will be more than happy to assist you contact

it is inside the engine compartment just follow the wires that go to the back of the light.you just unscrew the light and change the bulb.

First check the car manual.
I have done this repair myself. First pull back the trunck liner on the taillight needing repair. You will see two long bolts with nuts holding the taillightin place. Using a socket wrinch loosen the nuts completely. Fom the outside the taillight should be loose. grab the edge of the taillight and pull directly backward. Once out, you will see the individual bulb sockets. Replace the bad bulb. Test the lights, then reassemble.

wow - this sounds like a pain for the 2004 - assume it is same/similar to teh 2005 - details here

You have to carefully pull back plastic in the trunk directly behind the tail lights

Open the trunk, from the inside remove the side trunk liner (by removing the plastic tabs the liner can be pulled back). Once the liner is pulled back you will need to remove two nuts which secure the tail light in place. Once the two nuts are removed you can start pulling the whole tail light assembly out. There are two other tabs that secure the tail light in place which may give you some resistance but the light should come out without too much force once the two nuts are removed.
Once the tail light is out you can change whatever bulbs you need to.

jorgeva: on the driver's side to gain access, you must remove the air cleaner assembly. At that point, you can see the back of the light which has a plastic cap. Rotate this "counter clockwise" and you can pull it back from the back of the lamp housing. From there you will see how the bulb it self is plugged in, which is obvious. Unplug it. There is a "spring "like latch retainer to hold the bulb in place. Unlatch it, remove the bulb and install the new bulb.
CAUTION!!!!!!! DO NOT TOUCH THE GLASS AREA OF THE NEW BULB! Only handle the rear section. Reassemble in the reverse order.
The right side will require the removal of the windshield washer tank.
I trust this will have answered your question. If you would, let me or FIXYA know if I have solved your problem......

Pop The Trunk And Inside The Trunk, Immediately Behind Where The Light Is There Will Be A Panel Of Carpeting Remove It. Then You'll Have Access To The Rear Of The Light Find The Burnt Bulb Grasp And Twist As You pull. Then Pull The Bulb From The Harness And Replace.

it should be the bulb or a fuse get a test light and see if u have power to the brake light