2001 Kia Sephia Logo

Related Topics:

S
Samuel James Hope Posted on Dec 26, 2014

Makes noise whn its in gear and when Its stopped while still being in gear makes this noise like a vibration I cheked some valves on the intake they seemed to be fine kia sephia 2001

Cheked hosess took of the intake , checked a valve also the noise comes from the front in one type of gear and then from the botom of the car area inthe other

5 Related Answers

Scorpedo

Jamie Heppner

  • 111 Answers
  • Posted on Dec 12, 2008

SOURCE: car dies when driving,check engine light comes on.

There is a good chance it could be your fuel pump , however if the check engine light is coming on and the dealer cant tell you what is wrong , try a different dealer or another shop. Second opinions never hurt.

Ad

Anonymous

  • 99 Answers
  • Posted on Jan 24, 2009

SOURCE: Kia Sportage 2003 - Solenoid Valve

This sounds like the idle air control valve. This valve sits on the inlet manifold and basicly regulated the flow of air for tickover( or idle). The usual operation of this valve is, when the engine is running at high speed the valve will be closed, when the engine comes down to idle, the main throttle butterfly will shut as you lift your foot off the pedal. The idle valve will open and give a small amound of air to the engine, just enough to run it at idle speed. These valves can stick open, therefore letting air in when the throttle is open, giving the engine too much air. WD40 is only a temporary repair untill it jams again. Best course of action is to have part replaced.

TL

Anonymous

  • 91 Answers
  • Posted on Feb 11, 2009

SOURCE: 2000 Kia Sephia

it is the catalytic converter my answwer is 100 percent sure the catalytic converter gets clogged and does all of those also i have 1 same thing trust me

thanks,
Steve

Anonymous

  • 6784 Answers
  • Posted on Mar 01, 2009

SOURCE: Brake Fluid Type? 2000 KIA Sephia

any aftermarket brake fluid will be fine. the actual grade is located on the top of the fluid cap. you can find the universal grade at your local auto parts shop.

Jonah Oneal

  • 14092 Answers
  • Posted on May 20, 2009

SOURCE: 1999 Kia Sephia has an electrical drain that I cannot locate.

make sure your battery good have it load test.to make sure you dont have a shorted cell.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

My 92 ford ranger accellrtr sticks whn i chg gears

No that is no the issue, you likely have a leaking intake gasket or the idle speed control valve is defective.
1helpful
1answer

Nissan altama 2005 3.5 l v6 problems are running smooth when engine is cold 5-10 min there us a problem with engine vibrations on the stop i get the trouble code which is po0011

Here is the definition. You may want to do some research on the code and the valve that controls cam timing.

P0011 NISSAN Description This valve mechanism hydraulically controls cam phases continuously with the fixed operating angle of the intake valve.

The ECM receives signals such as crankshaft position, camshaft position, engine speed, and engine coolant temperature. Then, the ECM sends ON/OFF pulse duty signals to the intake valve timing control solenoid valve depending on driving status. This makes it possible to control the shut/open timing of the intake valve to increase engine torque in low/mid speed range and output in high-speed range.

The intake valve timing control solenoid valve changes the oil amount and direction of flow through intake valve timing control unit or stops oil flow. The longer pulse width advances valve angle. The shorter pulse width retards valve angle. When ON and OFF pulse widths become equal, the solenoid valve stops oil pressure flow to fix the intake valve angle at the control position.
Read more: http://engine-codes.com/p0011_nissan.html#ixzz26Hjx6ned
0helpful
1answer

1996 Dodge Ram 1500 vibration while driving only felt from drivers seat

No the idle issue is not the TPS, it is a sludged up throttle valve and automatic idle speed control air bypass valve. The procedure below should cure the idle issue. As far as the vibration goes this needs a hands on diagnosis by a good noise and harness trained tech, tire shops are good for this technican as well of course the Dodge dealer. Find below the cleaning procedure for the throttle valve and idle valve
Buy a can of throttle valve cleaner (it is made by CRC) from the local auto parts store, NEVER USE CARB CLEANING SPRAY, IT DESTROYS THE ANTI-STICK TEFLON COATING, spray it into the air intake through the throttle body of the engine until you have used about half the can, you will need to hold the idle up while you do this, it will try to stall, after this shut the engine down and disconnect the Negative (-) battery cable for 5 minutes. The intake is now clean, if you continue to have the idle speed control problems you may need to seek the help of a professional
0helpful
1answer

When i get on the gas i hear a grinding noise

is it a grinding noise, or vibration noise, as sometimes the heat shields can produce a vibration noise that can be misheard as a grinding noise......does this grinding noise go away as you brake ????...do you hear it more whn you go left or right ???
0helpful
1answer

On my 1995 automatic mustang when i press the gas and it switches gears from 2 to 3rd it vibrates then i let go on the gas and it stops when i press the gas again it does it again

The vibration may be clasified as a misfre. Suspect if it is somethig with the secodary igntion it would be wrse whn it is raining. The reason it does it more in 3rd gear is because there is higer load, and ignition relate misfires would occreider high loads. What do you think, Look under the hood on a damp night with someone brae torqueing then engine. You may see wires archig out.
0helpful
1answer

Vibration through the car Transmission-motor Linkage?

Check to make sure both headlights are tight,,,when it rattles at idle go feel the headlight and hold it and see if the noise and vibration goes away,sometimes the headlight has too much clearance and causes a massive vibration,,if thats not it try...loosening all the motor mounts and rock the car back and forth and them retighten them,it reseetles the mounts and sometimes fixes the issue,,also check the lower engine and trans mounts for wear.
0helpful
1answer

Engine rattles and idle

open the hood have someone u trust sit in the car and put it in drive holding the break with it in gear tap the throttle quick if the engine looks like it wants to jump out its a mount issue granted it will move about 3-4 inches if there ok anything more you have a problem try it in both (D) and (R)
Not finding what you are looking for?

80 views

Ask a Question

Usually answered in minutes!

Top Kia Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Brad Brown

Level 3 Expert

19187 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...