Question about 2007 Hyundai Accent GS Hatchback

1 Answer

What is the location of the fuel filter on a 2007 hyandai accent

Tried changing the spark plugs twice and still haveing a near stall issue every time i come to a stop

Posted by Bryce Neilson on

Ad

1 Answer

Daniel Dobbie

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 12 Answers

You would probably need to change leads as well and or run an injector cleaner through and take a long drive to get it through nice. Pretty shaw leads though.

Posted on Dec 13, 2014

Ad

5 Related Answers

ghost4548

Paul McGrath

  • 776 Answers

SOURCE: need to change fuel filter in 200o hyundai accent

0941de1.jpg Diagram of location of fuel filter.

c57a0e2.jpg

Posted on Jun 07, 2009

Ad
ghost4548

Paul McGrath

  • 776 Answers

SOURCE: i need to locate fuel filter on 2002 hyundai accent

Here's some photos


b112bac.jpg 6ed018b.jpg

Posted on Jun 02, 2009

ghost4548

Paul McGrath

  • 776 Answers

SOURCE: trying to find the fuel filter in a 2006 Hyundai Accent

YEP! It's in the fuel tank at the bottom of the fuel pump... it's called a 'SOCK.'

Posted on Jun 30, 2009

ghost45

PAUL MC G

  • 1280 Answers

SOURCE: Locating and changing spark plugs on 2007 Hyundai Sonata 4 cylinder

They are directly below the coil packs (10mm bolts).


a73d0bb.jpg

Posted on Oct 25, 2009

Jonah Oneal

  • 14092 Answers

SOURCE: where is the fuel filter

FUEL FILTER LOCATED UNDERNEATH CAR NEAR FUEL TANK.FUEL PUMP LOCATED IN FUEL TANK..

Posted on Oct 02, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When Istat my freestar, it shuts down. will not stay running


may the plug near the air filter is out or not fix i have the same issue and it happen after i clean the air filter i did not plug the plug nicely so it was stop some time and when i put the plug correctlly it is ok , i was about to change the sparkpluge and cable . but the issue was simple

May 06, 2014 | 2004 Ford Freestar

2 Answers

Changed transmission fluid on crv now car wont start


might be that you accidentally disconnected the crank sensor close to the transmission, this gives a no start condition without a check engine light on most cars...

Apr 19, 2014 | 2005 Honda CR-V

1 Answer

Causes stalling


seems like flooding
you remove spark plugs. see them soaked with fuel. flooding.
does car restart easy? never stated.
if you lose spark , the ECU cuts fueling, but not 100% of time.
so spark tests are first.
also make sure the EGR is not stuck open.
when the car starts to stall.
can the fast right foot , prevent it?
if yes, is it easy to do.or is it fighting you hard. or not possible.
now you have some ways and means.

Sep 16, 2013 | Honda Cars & Trucks

2 Answers

1996 Geo Prizm


could be lots of things, its EFI.
what you mech, does, is use tools and gauges. to gather evidence.
he also has a scan tool , to see what EFI is doing.
That jerking is called Misfire (not arguing names, ,but using the right name allows better google searches or getting help)
Misfire.
this can be (lost spark or lost fuel or too much fuel)
the prism has distributor, and if the car has and old cap, rotor and wires. then they are no good. finish the 60,000 mile tune up.
if its misfiring, it might be:
1: bad spark.
2: bad fueling.
bad spark ? tune it up fully this time.
bad fueling, is complex.
sure fuel pump, but why does the pump magically work on over 50 demand which is more demand?
my guess is lean misfire. at cruise.
when you go over 50mph the ECU can drop using the oxy sensor.
this is normal and goes rich.
so maybe the 02 front sensor is bad or an exhaust leak near it.
a scan tool can find this in a jiffy , a $50 tool)
you see the oxy sensor ,reading wrong or dead at low speed cruise.
ok stop sign stalls. (in order of most common 1st)
1: EGR main sticks open (clean it)
2: running rich and it misfires so bad, it stalls.
fuel pump reg bad? and fuel pressure way too high.
3: fuel starvation.
what a tech does, is make car fail, and look at the sensors to
see what is going wrong. Evidence, is first. guessing at parts never.
lets see the op guide shows the 60k as....
new cap,rotor wires.sparks. (they dont last 100k, sorry)
new fuel and air filter.

May 01, 2013 | Geo Prizm Cars & Trucks

1 Answer

Engine stalls on Isuzu I-370 truck after warm up


The Cam sensor usually senses the position of the timing belt or timing chain gear and tells the computer when #1 cylinder is at top dead center. In other words, when #1 cylinder comes up. Crank sensor tells the computer when to fire the spark plugs in the rest of the cylinders. In other words, as the crank shaft goes around it tells the computer when each piston comes up so it can fire it's spark plug


so replace the crankshaft sensor

Jan 04, 2013 | 2007 Isuzu I 370

1 Answer

2001 Honda CRV 340,000km 5speed Manual Vehicle was running perfectly for two years, no a single issue. Been driven on 5hour+ each way road trips, take it out of town all the time, lots of highway...


The oil when hot shouldn't be above the hot mark (the highest mark on the dipstick). If it is much higher than this it may cause too much lower end compression and bog or stall the engine. It may also cause blow-by, causing the oil to be burned in the cylinder.

Aside from that possibility, also pull out your plugs and check their condition. Also check the condition of your plug leads.
If they all seem fine, then check that your plugs are receiving a healthy spark.
Check the condition of your:
Fuel filter
Air filter.

Nov 12, 2012 | 2001 Honda CR-V

1 Answer

Timing issue??


Check vaccum at PCV to ensure there is 18-20 lbs. of vacuum pressure if lower than 18 there is a vacuum leak trace it down. Also check compression in each cylinder to ensure the pressure is equal within 15 psi in all cylinders, if there is a low pressure reading in one cylider this si your problem. It could be as simple as a bad spark plug or plug wire a good way to narrow it down is to remove each spark plug and look for the one that is black or really worn all plugs should be a dull tan color if not there is an issue with ignition.

Sep 11, 2009 | 2002 Nissan Maxima

3 Answers

Car randomly stalls when i stop or even while i drive


It sounds like your fuel filter is clogged or your fuel pump is going bad. When this happens see if you can hear if your fuel pump is running. Turn the key forward to the run position and listen near the gas tank. you should hear a vibrating sound. If you don't hear it at all the pump of pump relay is bad. If you hear it continually your fuel filter, pressure regulater, or fuel line have problems.

Jul 25, 2009 | 1999 Honda Accord

Not finding what you are looking for?
2007 Hyundai Accent GS Hatchback Logo

443 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...