Question about 2010 Jeep Liberty
Blend door is not moving to open to the heater core. Coud be that the cable is not connected to the dash lever but if it's vacuum actuated the vacuum line could be off. Check that your getting vacuum.
Posted on Dec 01, 2014
Most of the time it's because the cooling system is not completly full just a quart low will make it do this and if it's low theres a leak somewhere so it needs to be found and fixed. as simple as the hse from the raditor cap to the resivoir or the cap being bad or just dirtly. If anything appears dirtly not clear fluild green or red but clear then you need to flush the system. and then make sure its filled completly and recheck after youve drove it as its diffacult to get all and air out and your problem will be corrected.
Posted on Dec 05, 2009
Coolant level could be low. Might need a new thermostat. If the coolant level is low you likely have other issues. Check back here if that's the case. I hope this helps..
Posted on Mar 15, 2010
OK. So the blower notor isn't operating. Do you have power to the blower motor? The resistor is new from what I got. If you don't have power to the blower motor, then check the speed control switch and fuses. If you have power at the blower motor, replace the blower motor
Posted on Jun 16, 2010
Tips for a great answer:
Nov 18, 2017 | Jeep Cars & Trucks
Nov 01, 2015 | 2005 Jeep Liberty Sport
Dec 01, 2014 | 2010 Jeep Liberty
Jul 16, 2013 | 2010 Jeep Liberty
Jan 03, 2012 | 2010 Jeep Liberty
Dec 01, 2011 | 2005 Jeep Liberty
Jan 21, 2011 | 2003 Jeep Liberty
Dec 08, 2010 | 2006 Jeep Liberty
Jul 01, 2010 | 2002 Jeep Liberty
Mar 24, 2010 | 2003 Jeep Liberty
575 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: