I purchased this 2002 RV used. It came from the factory with a stereo cassette player. I want to upgrade to a CD player with bluetooth. How do I remove the existing stereo cassette player?
SOURCE: stereo error code
The code for the radio needs to be input.
the radio must have been disconnected from the battery.
look for the code on a card in the glove box.
if no card, then u have to pull the stereo out and get the serial #
to the dealership.
SOURCE: 1998 - 2002 Honda Cassette 6 disk CD changer Radio
the cd changer is malfunctioning, the factory cd changers usually don't last that long because of the heavy use and many mechanical puts
SOURCE: Replace 2005 Nissan altima stereo receiver
Try radio shack, or stereo sales/installation place for ready to go plug adapter. For a few bucks, it saves headaches, and butchering the wiring in case you want to re-install old one later when trading in or selling the car.
SOURCE: removing factory installed radio (trim panels) to install another
CAUTIONOn
models with an airbag, wait at least 90 seconds from the time that the
ignition switch is turned to the LOCK position and the battery is
disconnected before performing any further work.
Remove the upper and lower screws from both sides of the radio brackets
Extract the radio with brackets and ashtray out of the dash
Disconnect the wiring harness from the back of the radio, along with the antenna leadTo install:
Good luck....
SOURCE: replace factory radio on 2002 yukon xl
all you gotta do is carfully pry the dash panel off (prying from the far left end is easiest) completely remove panel. then there are 2 clips that hold the factory sterio in place. push on the both clips while pulling the radio out. simply disconnect the wiring harness from the back of the radio. using an adapter avaliable at your local radio shop (scosche p/n gm02, mdarb and gm1483b) wiring harness, dash install kit, and antenna adapter. then simply match the colors on the new radio's harness to the adapter harness, crimping each connection with a "but plug". then simply follow the instructions included with the dash install kit to assemble the kit.connect the antenna adapter to radio, plug in all cables. test to see if everything works properly before the final install. install sterio into dash install kit, re installing kit where origional radio was. then simply put the panel back in its place by firmly pushing on it untill it snaps into place. then enjoy your new radio!
590 views
Usually answered in minutes!
×