Fuel preasure specs

Question edited for clarity and written English.
Question moved from H D Motorcycles.

https://www.google.com/search?q=2011+Ford+f150+Harley+Davidson+edition+inertia+switch

..

you have a number 5 cylinder misfire code. three possible causes-spark plug is bad, coil pack failed, or fuel injector is plugged up or has an open wire. good luck in pinpointing the culprit!

yes it can be the ignition, starter, wiring, short, ecu box is fried, etc etc etc. never take em to the dealer they mess things up just to get more money.

Please email me the engine size information on reply.
Pick one from below.
V6 - 4.2L vin 2 256ci - MFI GAS OHV V8 - 4.6L vin W 281ci - MFI GAS SOHC V8 - 5.4L vin 3 330ci - MFI GAS SOHC Super-charged V8 - 5.4L vin L 330ci - MFI GAS SOHC V8 - 5.4L vin M 330ci - MFI CNG SOHC V8 - 5.4L vin Z 330ci - MFI BI-FUEL SOHC Harley-Davidson Edition -- V8 - 5.4L vin L 330ci - MFI GAS SOHC Lightning -- V8 - 5.4L vin 3 330ci - MFI GAS SOHC Super-charged
====
Please identify the color of the leakage.
Green? brown/rusty? oily?
Most likely is coolant leak but on high mileage engine it can be oil vapor + morning cold air condensation.
How many miles is on this engine?
How much water leakage is seating on for of the engine?
Is it in on particular spot?
====
I strongly recommend you to open a CHAT SESSION instead of a single page email session.
You will need a lot of back and forth Question and Answer to trouble-shoot this leakage problem.
I will glad to help if you post a CHAT SESSION.

This code is saying the fuel preasure is too high, this may be caused by a stuck fuel preasure control valve or a bad fuel rail preasure sensor, you would need to first check the valve to make sure its not stuck then test the preasure sensor, to test sensor a scan tool would be very helpful. hope this helps.

map sensor

check the fuel preasure, make sure it has enough fuel preasure, then take a look at the sparkplugs and wires and cap and rotor,

Check the ampage on your fuel pump, it shouldn't be lower than 4- 5 amps. If it is too high, the motor is going bad in your fuel pump.

Good day
the location of the fuel filter in left side of truck along the frame. you can use the drv's door as a land mark look approx the middle of the door, it should just be around there
how this helps

Cheers

It most likely has water in it but not enough to turn the light on constantly