How do i replace fog light on 1999 buick regal

SOURCE: Buick Regal brakes

28-DEC-08
Sometimes (when changing the brake calipers on disk brakes, or changing wheel cylinders on drum brake systems) the mechanic will clamp a vise grip pliers on the rubber hose to prevent hydraulic fluid from dripping out.  This can break the internal fiber lining in the rubber hose.  Then the fluid flow can be blocked.  When you press the brake pedal, fluid may not flow to the wheel or wheels.  As you press harder, the fluid may suddenly flow through the line, causing the brakes to suddenly activate.  
Or an even more likely problem, your brakes drag (stay on) and get hot, because the fluid cannot flow back to the master cylinder when you release the brake pedal.  In other words, when you press the brake you force fluid through a partially blocked rubber hose.  But the return of the fluid (backwards through the rubber hose) is caused not by pressure, but just by equilibrium, a balancing act.  Well, if the line (rubber hose) is blocked, the fluid stays in the caliper or wheel cylinder, and the brake is still on, and the brake gets hot.  
Ken   Camas, Washington [email protected]

Posted on Dec 28, 2008

SOURCE: wheres the supercharger oil plug in the buick regal/1999

if you look on the top of your supercharger, you will see it. u have to get it out with a hex screwdriver

Posted on Feb 06, 2009

SOURCE: 1999 Buick regal Security light on. Won't start.

I had the same problem with my 95 Lesabre. The owners manual says to take the key out, and wait 3 minutes(until the light goes off). It should fire right up.

Posted on Feb 26, 2009

SOURCE: how do you replace the fog light bulbs on a 2004

Notes FOG LAMP BULB REPLACEMENT - FRONT

REMOVAL PROCEDURE

1. Remove the front bumper fascia deflector.
2. Disconnect the electrical connector from the front fog lamp bulb/socket. CAUTION: Refer to Halogen Bulb Caution in Service Precautions.

1. Rotate the front fog lamp bulb/socket counterclockwise to release.
2. Remove the fog lamp bulb/socket from the front fog lamp assembly.

1. Install the fog lamp bulb/socket to the fog lamp rotating clockwise until fully seated. CAUTION: Refer to Halogen Bulb Caution in Service Precautions.

1. Connect the electrical connector to the front fog lamp bulb/socket.
2. Install the front bumper fascia deflector.

Posted on Jun 17, 2009

Marvin

• 85239 Answers

SOURCE: water on passenger side floor of Buick Regal

U need to clear the AC condensation drain, crawl under the car on the passenger side and near the base of the engine firewall u will find a drain pipe, (about 3/4") clear t and the water will stop going on the passenger floor.

Posted on Aug 30, 2009