Where is the inertia switch on a1995 crown victoria

Mike Schmidt

• 227 Answers
• Posted on Jan 19, 2009

SOURCE: 1987 Ford Crown Victoria LTD

If it was an old police vehicle it has probably got an ignition kill switch located somewhere. This will have to be removed. And the wiring put back to factory standards. If not an old police car you are not getting voltage to the starter which is a bad relay. Do you get a clicking sound when you try to start? If yes, have someone keep hitting the start and listen and look for a relay under the hood.

SOURCE: crown victoria window motor replacement

remove the door panel. be very careful and make sure you get all the screws out. Should be maybe 2 on the bottom half of the door, and 2 on the top half. one is right by the handle, which is the one i forgot the first time i took my door pannel off. carefully pull the panel upward, and outward at the same time. Once the panel is off, disconnect the controls, and remove the light from the panel. Remove the plastic cover very carefully, it will tear, just keeps noise, and air, and the elements out.
There will be 3 screws, they are torx bolts, once you pull those 3 out. They are located middle of the door towards the right side. The motor will drop down a little bit. disconnect the wires for the motor, and wiggle the motor off of the regulator. the crown vics have a decent size hole to get into the door panel, you can also remove the speaker if that would help you do it. other than that, it just lining up the new motor into the car, pushing it into the regulator, and putting the 3 bolts in, make sure they are snug, and not cross threaded. put everything back together, and your set.

SOURCE: need wiring diagram for 2008 ford crown victoria

Hello,

You can purchase the wiring diagram for $5.99 from the following site: http://www.wiring-diagram.com/. You can also purchase a wiring diagram book from the following link: http://cgi.ebay.com/ebaymotors/2008-FORD-CROWN-VICTORIA-MARQUIS-WIRING-DIAGRAM-MANUAL_W0QQitemZ120394723100QQcmdZViewItemQQimsxZ20090320?IMSfp=TL090320147007r15080.

Hope this helps,

Chris

SOURCE: 2000 crown victoria serpentine belt installation

Accessory Drive Component Locations

SOURCE: fuse diagram for 2000 crown victoria

there are 5+ pages of fuses what specifically do you need