2005 Chrysler pacifica egr valve solenoid wiring diagrams
SOURCE: Brake fluid reservoir on a 2005 Chrysler Pacifica
WHEN YOU OPEN YOUR HOOD LOOK DOWN THE DRIVER SIDE FENDER THEN LOOK LEFT ABOUT 10 INCHS AND YOU SOULD FIND IT IT WILL BE WHITE IN THE ENGINE COMPARTMANT AREA
SOURCE: How to remove the right rear door panel on a 2005
you need a tool pry the panel from clips. you need a haynes manual to tell you where all your screws is located to move door panel.
SOURCE: program instruction garage door opener in 2005 chrysler pacifica
if your garage motor have rolling codes you need to put your car inside garage near the motor leave ignition on go to the motor locate learn button press it then quickly go to the car and press and hold one of the buttons for approximately 30 sec or until it start blinking rapidly, if you have a regular motor take one hand held opener go inside car ignition on same time press open button on handheld remote and on the car button 30 sec and it should be programmed.
SOURCE: How do you replace the EGR valve on a 2004
check with you dealer, that part may have a manditory extended warranty by law
SOURCE: 2006 Chrysler Pacifica serpentine belt routing
here are a couple diagrams...
If you need anything else, let me know.
EGR Solenoid Circuit
Possible Causes:
EGR solenoid ground circuit is open.EGR solenoid control circuit is open or shorted to ground or to voltage.EGR solenoid power circuit is open.EGR solenoid is damaged or has failed.http://www.autozone.com/autozone/parts/Duralast-EGR-Valve/2004-Chrysler-Pacifica-2WD/_/N-jlfixZ93xpy?itemIdentifier=857100_0_0_PCM has failed.HERE IS THE EGR VALVE.CLICK ON LINK TO VIEW.
394 views
Usually answered in minutes!
×