Has not run for a while. Tried the 0+# negative terminal with 4x(0's) method that worked last time but time... nothing. Already rang Subaru and they reckon I have to tow it 400kms to the nearest dealer. Any suggestions?
Do you have power in the dashboard? does the starter turn? if not check related fuses. also there is a small wire which should be connected to the starter sometimes they fall off when bumped and it will not crank. there can be many other reasons though.
SOURCE: cannot connect the negative battery terminal without spark or starter turning over
You will need new igniton cylinder. Sounds like you have a short in the cylinder.
SOURCE: can't find negative connection on remote terminal battery
Just attach the negative cable to any metal ground. This will protect the battery in the Olds and still enable you to jump start your car. Best of luck.
Greg
SOURCE: car drags when trying to start. had battery
Clean positive cable! But take off neg. first to avoid arching. Put positive back on first then reconnect negative. Use a amp. draw meter to see if starter draw is not too high. You may need a new starter.
SOURCE: wiring loom diagram for subaru 97 sti & 00 ra ?
can any1 help me as my interior light not workin with doors when i use door settings get nothing till i close the doors and it comes on dull
SOURCE: service engine soon light came on. AutoZone read
Sometimes you have to wait a week for the light to go off, the computer has to go through several start/run/stop cycles.
40 views
Usually answered in minutes!
×