Toyota Corolla 95 Hi, I am actually getting a clunky sound from right hand rear side of my car when ever there is someone sitting and I turn left, feels like the shocker in touching the tyre, for that I have replaced my both rare shocks but problem still exist?

SOURCE: replace rear seat belt in 1993 Toyota Corolla

OK. On the front edge of the seat bottom cushion, pull up hard, both sides. This will dislodge the 2 clamps that holds the seat cushion to the floor. Pull the seat cushion out & set it aside. You will now see the female latches bolted to the area where the rear of the seat cushion meets the rear seat back bottom. Remove the bolts (14 mm I think).

SOURCE: noise from the rear of my 97 crv when turning left and right

Does the noise have any sort of metallic sound to it? I had a '97 CR-V and when I turned hard right or left it would slighty bind the exhaust sytem. Just enough over time to cause the spot welds on the heat shield over the resonator (the "muffler" behind the catalyst) to fail. When I'd turn sharp, the heat shield would lift slightly due to the failed welds and vibrate against the resonator. Took a bit of head scratching to find this one.

Take care.

SOURCE: 1998 Toyota Corolla Electric Door Lock Problem

You'll need to replace the solenoid (motor) that doesn't work. Not hard once you get the door panel off. I suggest you buy the correct part, not a universal one.

SOURCE: 2001 Toyota Avalon - Rear signals

Check the front lights. Usually if i flashes fast it indicate a bulb is out on that side.

SOURCE: 2003 Toyota Corolla Wheel Alignment

The specs are what the manufacturer recommends for the vehicle when it leaves the factory. However that means with the original tires and condition. The caster is not adjustable on a Corolla, so if the vehicle pulls even with the tires switched, there is a possibility there is damage to the strut or steering parts. However, before changing anything, check all tire pressures and make sure the brakes are in good condition. A brake that is not releasing properly will cause a pull to that side. Individual toe is rather meaningless - the total toe is what is measured. You have no king pins on a Toyota so you will not have KPI.