2000 Chrysler Town & Country Logo

Related Topics:

A
Anonymous Posted on Oct 09, 2014

Electrical current not getting to transmission Chrysler 2000 town and country

Won't go beyond 2nd gear, odometer not working, speedometer not working, changed 1 module in transmission, still not working

5 Related Answers

garyq1970

Gary Queen

  • 85 Answers
  • Posted on Aug 24, 2008

SOURCE: changing fuel filter on 2004 chrysler town and country

  1. Remove or disconnect the following:
    • Negative battery cable
  2. Raise the vehicle and support the fuel tank with a transmission jack.
    • Fuel line from the front of the tank
    • Ground strap
    • Inboard side of the fuel tank straps and front T strap fastener and lower the tank about 6 inches
    • Fuel lines from the fuel pump module
    • Fuel filter
  3. Installation is the reverse of removal. Tighten the fuel filter bolts to 40 inch lbs. (4.5 Nm), the main tank straps to 40 ft. lbs. (54 Nm) and the T strap to 250 inch lbs. (28 Nm).
  4. Start the engine and check for leaks.

Ad

Anonymous

  • 125 Answers
  • Posted on Feb 04, 2009

SOURCE: 2002 Chrysler Town & Country Speedometer does not work

your vehicle is equipped with a speed sending unit and that must be faulty and need changing it is fairly expensive and usually only the dealer carries it but I know a good salvage lot in Oregan might have it cheaper heres there number Peach street autorecycling 18003652341 good luck and dont forget to rate this if I helped.

Anonymous

  • 4669 Answers
  • Posted on Mar 02, 2009

SOURCE: 2003 chrysler town and country speedometer quit working

It is the speedometer that doesn't work? What problem do you have? Does the transmission shift or is it stuck in 2nd?

emissionwiz

Marvin

  • 85242 Answers
  • Posted on Mar 23, 2009

SOURCE: where is the body control module located on a 1997 town & country

It is located on the back side of the underdash fuse box (junction block). You remove the lower steering column cover and knee blocker reinforcement. Then remove two plugs from the bottom of the BCM.
Remove the bolts holding the junction block to dash panel mounting bracket. Remove the junction block from the bracket. Remove screws holding the BCM to the junction block. Slide the BCM downward to disengage guide studs on jb from channels on BCM mounting bracket

Anonymous

  • 1 Answer
  • Posted on Jun 07, 2009

SOURCE: country speedometer doesn't work and won't shift out of 1st gear

transmission speed sensor needs replacing about 40.oo$ at the dealer sits on the right side of transmission looking from the front of the radiator g s.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer
0helpful
1answer

Why is my speedometer and odometer stuck at zero?

Could be a problem with the engine computer, or the speed sensor in the transmission.
Is the check engine light on ?
0helpful
1answer

Speedometer not working

Could be the speed sensor on the transmission or the speedometer on the dash. Does the odometer work ?
0helpful
1answer

1997 Chrysler Town & Country, codes; p1698, p0734, p1782, p1788, p0732, p1787, and p0700? Plz help

You will need the help of a transmission repair shop or the dealer, there is a serious transmission problem and it will require special test equipment and training to find the cause, which is likely a wiring harness issue.
1helpful
1answer

I notice that sometimes my 98 chrysler town an country jumps from 1st gear to 2nd gear to soon. Does that mean that my transmission is starting to go out?

If it is only happening sometimes, you should get your transmission serviced ASAP. If you do this you should be able to save the transmission.
7helpful
1answer

Country speedometer doesn't work and won't shift out of 1st gear

transmission speed sensor needs replacing about 40.oo$ at the dealer sits on the right side of transmission looking from the front of the radiator g s.
43helpful
1answer

2003 chrysler town & country speedometer stuck

sit in the drivers seat close the door. with the key off hold the trip odometer button in then while holding the button in turn the key on. if done correctly this will put the MIC (mechanical instrument cluster) into a self test. if the speedometer does not move like the rest of the gauges during this test the MIC must be replaced. if the speedometer does move it is likely your problem will be fixed, however, if the speedometer does move but it does not start working properly then further diagnostic will be needed.
0helpful
1answer

2003 chrysler town and country speedometer quit working

It is the speedometer that doesn't work? What problem do you have? Does the transmission shift or is it stuck in 2nd?
0helpful
1answer

Everything on dash panel not working.

Fuse for the instrument panel is possibly blown. Check your owners manual for the proper location of the fuse. If you do not have a manual they are available online in PDF version.
Not finding what you are looking for?

85 views

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...