If you have fitted a clutch kit then the clutch plate is in the wrong way round and the centre hub is fouling the flywheel bolt heads. If not then there is a possibility that the throw out bearing has failed and not pushing the pressure plate fingers in far enough to stop the clutch input shaft from spinning
SOURCE: transmission problems (gear linkage)
The gear linkages are not correctly aligned.
Is the gearbox mounting in exactly the same place as when you removed it?
Even a 1/4 inch will offset the gears.
hope this helps
SOURCE: my 92 honda accord will not go into 1st 3rd or 5th gear
check shift fork adjustment. make sure you bleed the slave cylinder.also check shift cable adjustment.
SOURCE: sudden noise, whining in 1st gear, reverse jerky
Sounds like your final drive pin in your differential broke causing the main spider pin to tear through the case.Catastropic damage.Check for severe fluid leak under car.If no signs of leaks,check dipstick for greyish blk colored fluid.If this is the case you will need to replace transaxle & flush trans cooler.hope this helps
SOURCE: 1995 Sabb 900 clutch wont engege in reverse
Bad syncro for third gear. Sorry, but you aren't fixing this one yourself, unless you replace the transmission yourself.
SOURCE: my ford focus tdi 2003 cant select 1st,3rd or 5th gears.
Car is in limp in mode unless you have the tools to work on automatic transmission you will need to take it to a transmission shop. Of course you can check oil level but I suspect you have other issues.
63 views
Usually answered in minutes!
×