Question about 2007 Chrysler Pacifica FWD New Cars
Posted by Anonymous on
this is a one piece part hub and bearing assy. even if auto parts sales you bearing separated highly recommend to replace whole unit
Posted on Nov 19, 2009
replace restor open glove box uplug 4 wire plug and two wire plug put 12 volts two wire plug to mke sure fan works if it does replace restor
Posted on Dec 27, 2009
Hello, seems like your thermostat may be stuck open. After the vehicle been running more than 10min feel the upper radiator hose it should be hot to the touch and if not a new thermostat is needed.
Posted on Mar 27, 2010
1. Open liftgate. 2. Remove both taillight assemblies by removing 2 hex-head bolts located in the area revealed when the liftgate is opened. 3. Remove 4 plastic retainers on the very bottom of the bumper cover in the rear. 4. Remove 2 phillips head screws in the wheel well rear lip. 5. Remove 4 pop-up plastic retainers in liftgate area. Use two screw drivers to lift the head and then pull the entire retainer out. 6. Remove a hex-head bolt from each side in the area revealed when the taillight assembly was removed. 7. Bend the bumper cover outward on each side to clear the wheel well lip and remove the bumper. Have a blanket or carpet on the ground to protect the bumper. 8. Remove metal clips from tabs that connect the upper bumper cover to the lower bumper cover. 9. Drill out pop-rivets that connect upper bumper cover to lower bumper cover. 10. Push tabs out of slots to separate the upper and lower bumper covers. 11. Release tab locks on chrome trim pieces and remove from upper bumper cover. 12. Reverse this process to replace the bumper cover.
Posted on Sep 28, 2010
SOURCE: how do I get the
Fig. View of the actuator (1), support (2), adjuster spring (3), return spring (4), caliper adapter (5), shoes (6), hold-down clips and pins (7) and adjuster (8) Fig. Hub assembly Fig. Rear hub and bearing mounting bolts
Removal & Installation NOTE The following procedure may be used to remove shoes on either side of the vehicle.
NOTE Before installing shoes on actuator, make sure actuator hooked to rear cable is positioned with word -UP- facing outward.
Adjustment This vehicle is equipped with permanently sealed rear wheel bearings. There is no periodic lubrication or maintenance recommended for these units.
Removal & Installation
Fig. View of the actuator (1), support (2), adjuster spring (3), return spring (4), caliper adapter (5), shoes (6), hold-down clips and pins (7) and adjuster (8)
Fig. Hub assembly
Fig. Rear hub and bearing mounting bolts
Posted on May 18, 2011
Tips for a great answer:
Mar 25, 2018 | Chrysler Cars & Trucks
Sep 08, 2015 | Chrysler Cars & Trucks
Jun 10, 2014 | 2004 Chrysler Pacifica
Mar 12, 2014 | 2007 Chrysler Pacifica Touring
Apr 28, 2013 | 2007 Chrysler Pacifica FWD New Cars
Aug 07, 2012 | 2007 Chrysler Pacifica Touring
Nov 19, 2010 | 2005 Chrysler Pacifica
Sep 17, 2009 | 2006 Chrysler Pacifica
86 people viewed this question
Usually answered in minutes!