How do I remove the power window motor on a 1985 Chevrolet el camino?
Replace power window motor on 1985 Chevrolet YouTube
Not the el camino but probably close enough
SOURCE: replace the window motor power window bolts and rivets
Take the panel off the door and take a punch and drive the pins out of the center of the rivets. Then drill out the rivets.( easy with the center pins out) Take out the assembly. Note remove the window before you start anything. 2 X 8MM bolts clamp the bottom of the glass. When down the most of the way the window will lift right out.
Replace the assembly and either rivet back in or use bolts and locking nuts. ( Loc Tight is recommended if you are not sure the nuts will stay locked. replace the window and you are good to go.
This should take about 1 hour from start to finish.
SOURCE: rewiring 1959 chevy el camino
Are you needing advice, links, tricks, or all of the above?
If it's advice you want:
If you are not buying an after market harness and all of the oem wiring is intact replace one wire at a time from the component all the way back to the fuse box. Its tedious but, it's a sure fire way to get it right the first time.
Secondly, I'd by a haynes manual or some other wiring diagram. Study it for at least a couple weeks or until you are completely comfortable taking on the task.
Color code your wires and label both the old and new ones with paper tape and a permanent marker so that you know what each one is for.
Last but not least, make sure that the battery is disconnected... ;o)
SOURCE: 1983 Chevrolet El Camino maintenance manual heater blower proble
OPEN HOOD LOOK ON PASSENGER SIDE BY HOOD HINGE ITS THE ROUND BLACK THING ABOUT THE SIZE OF A BEER CAN
SOURCE: 2001 chevrolet prizm power window motor is bad.
You can just put proper length(tight) wood stick , between window and bottom of the door to keep it up forever.
SOURCE: how do i replace the
you need to disconnect the speedometer then remove the 6 or 8 screws that hold the instrument panel to the dash.if its an automatic you will have to unhook the shift indicator cable from the shift colume.then pull the instrument panel out of the dash,turn the panel upside down and you will see the bulb sockets.replace all the bulbs at this time so you won`t have to do this again for another bulb.when hooking up the shift indicator cable make sure it indicates the properly selected gear when moving the shifter to each gear position.
315 views
Usually answered in minutes!
×