Question about 2002 Cadillac Seville

Open Question

Where is the Speedometer fuse for a 2002 Cadillac STS. Where is the fuse for the dash board display

The dash board display says " Service " but the information reset button does not work either

Posted by Anonymous on

Ad

5 Related Answers

240cpa

  • 548 Answers

SOURCE: 2002 cadillac sts headlight problem

Why did you pull them out? I suspect that the right one did not get seated properly or there is corrosion in the connection - is the housing watertight? I don't think it's a relay since neither would work. Could be a bad ground connection on that side.

Posted on Jan 25, 2009

Ad
bunnydawg

Roberta Smith

  • 5158 Answers

SOURCE: Spark Plugs for 2002 STS Cadillac

follow the spark plug cables.. one end is the coil pack... the other end is the spark plugs if you still can't find them... that's not a diesel by chance is it ?

Posted on Feb 26, 2009

Ad

Anonymous

  • 365 Answers

SOURCE: 1998 cadillac seville sts air ride prob

Disconnect the - battery terminal for a minute and reconnect.
Good Luck

Posted on Jun 14, 2009

Anonymous

  • 359 Answers

SOURCE: i have a 2002 caddy sts, service suspension sys

have the codes cleared but if there is an issue in the system it will come back on find out what codes are in the system

Posted on Jul 11, 2009

Anonymous

  • 359 Answers

SOURCE: where is the fuse box in a 2005 sts cadillac

one under the hood one on the drivers side of the dash

Posted on Nov 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I remove the service notice from the dash board? It's for an Audi A3 2006 model.


Service reset:

Note: This reset method applies only to vehicles with a fixed maintenance schedule. All other vehicles: reset using special VAG equipment, or similar.

tdisline_836.jpg
1. Turn the ignition ON.
2. Pull out button [2].
3. "SERVICE IN ???? KM" or "SERVICE !" appears on the display.
4. Pull button [2] until the indicator shows: "----".
5. Press the reset button [1] within 5 seconds.

The system is reset.

Aug 18, 2011 | 2006 Audi A3

Tip

How to Reset the Service Indicator on a BMW X5


In this Tip I am going to set out the exact procedure you need to carry out in order to reset the service indicator on your BMW X5.

This is very useful information if you are doing your own servicing or having your vehicle serviced by an independant mechanic who may not have the specific service reset procedure for your vehicle. In this case you can reset the service indicator yourself by following these steps:

  1. Get in the car, close the door, buckle the seatbelt.
  2. Push in the clutch pedal and hold it to the floor
  3. Press the left hand dash button (the one that resets your odometer) and hold it down
  4. Put the ignition key in the key slot, and turn it gently (very gently) until the dashboard lights come on - the key will not click - if it clicks you've gone too far and you have to start again. Hold the key in this position. In five seconds or so, the dash will display "SIA" and some other characters. Do not proceed until this happens.
  5. Release the dash button (and only the dashboard button) and then press and hold it again. In another 5 seconds or so the display should begin to flash "RESET?" Do not proceed until this happens.
  6. Release the dash button and push it again to confirm. You won't need to hold it - the display should change immediately and your service indicator will display five green LED's.
Your Done!!

If this Tip has helped - please reflect this with a rating using the buttons below.

Many thanks for using FixYa.

on Dec 19, 2009 | BMW X5 Series Cars & Trucks

Tip

Volkswagen Service light 1993-99


Beetle,
Golf,
Jetta,
GTI,
Cabrio


1993-99

Note: the Service Reminder Indicator displays 3 messages: OEL, IN 01, and IN 02. These display to alert the driver to follow the items listed under the manufacturer's service interval.

To reset the message displays, turn the ignition switch on. Press and hold the odometer reset button "A" located below the speedometer. Turn off the ignition while holding the button. "OEL" will display on the indicator. Press and hold the lower digital clock reset button "B" until five dashes appear in the display. If needed, press the odometer reset button until "IN 01" appears and then press the clock reset button until five dashes appear. If needed, press the odometer reset button until "IN 02" is displayed and then press the clock reset button until five dashes appear.

To exit reset mode, turn the ignition switch on and when "IN 01" appears, turn the ignition switch off.

on Dec 07, 2009 | Volkswagen Jetta Cars & Trucks

1 Answer

How to reset the clock on dash


I'm thinking that your talking about the VIC is the Vehicle Information Center... Its the display unit between the radio & the ashtray.

You have to hold the "set" button while the time/date is displayed. Use the set button to change each section, then select to cycle through.

Hope helps with this.

Feb 04, 2010 | 1993 Jeep Grand Cherokee

1 Answer

I need to reset the service alert on the dash (mercedes ML ,2002)


Within the first 4 seconds after moving the start switch to position 2, press the reset button for the trip counter twice within one second. The display for the service request is activated for about 10 seconds.

Within these 10 seconds, move the start switch into position "0". The service request continues to be displayed.

Press the reset button for trip counter and keep it pressed.

Move the start switch into position "2".

Continue to hold the reset button for the trip counter pressed until the signal sounds and the new start distance appears in the display (it takes about 10 seconds).

Nov 08, 2009 | 2006 Mercedes-Benz ML-Class

Tip

Ford service light procedure 1994-01


Windstar

1999-01

To reset CHANGE OIL SOON/OIL CHANGE REQUIRED message on the message center, press the SETUP control to access the System Check mode. Press and release the RESET button until IF NEW OIL HOLD RESET is displayed. Press and hold RESET button until OIL LIFE SET TO 100% is displayed.


Windstar


1997-98

To reset "CHANGE OIL SOON/OIL CHANGE REQUIRED" message on the Message Center, press "RESET" and "SETUP" controls at the same time. "OIL LIFE % HOLD RESET NEW" will be displayed. Press the "SETUP" control to access the System Check mode. Press "RESET" to start the system check. Press and hold the "RESET" control. Press "RESET" and "SETUP" to reset the system to 100%


Explorer,
Mercury
Mountaineer


1997-01

To reset the oil life feature on the Message Center, press and hold the "OIL CHANGE RESET" button until the system counts down (about 5 seconds). The Message Center will display "OIL LIFE RESET TO 100%"


Probe

with Analog Dash

1989-92

When "SERVICE" is illuminated on the Vehicle Maintenance Monitor on the overhead console, press the "SERVICE INTERVAL RESET" button located directly above the light.


Probe

with Digital Dash

1989-92

When "SERVICE" is illuminated on the Vehicle Maintenance Monitor on the overhead console, press the "SERVICE INTERVAL RESET" button located directly above the light.


Probe

with Digital Dash

1989-92

When "SERVICE INTERVAL CHECK" is displayed is displayed on the far left side of the instrument panel, press the "SERV OFF" button, located on the speed alarm keyboard, until three tones sound.


Thunderbird,
Mercury Cougar

with System Scanner

1986-88

When "SERVICE" appears on the Diagnostic System Scanner, press the "ODO SEL" and "TRIP RESET" buttons simultaneously. The "SERVICE" message will go out and three short beeps will be heard when the system is reset.


Thunderbird,
Mercury Cougar


1989-94

If "CHANGE OIL SOON" or "NOW" is indicated on the Monitor, turn the ignition on, but do not start the engine. Within 16 seconds, insert a paper clip into the cavity to the left of the display and depress. The display will flash; when it stops, the system is reset.















on Dec 07, 2009 | Ford Windstar Cars & Trucks

3 Answers

How do i switch off service now light on my vw golf 53 plate


Courtesy www.synthetic-direct.ca:

To reset the message displays, turn the ignition switch on. Press and hold the odometer reset button “A” located below the speedometer. Turn off the ignition while holding the button. “OEL” will display on the indicator. Press and hold the lower digital clock reset button or the analog clock reset button “B” until five dashes appear in the display.
If needed, next press the odometer reset button until IN 01 is displayed and then press the clock reset button until five dashes appear. If needed, next press the odometer reset button until IN 02 is displayed and then press the clock reset button until five dashes appear.
To exit reset mode, turn ignition switch on and when IN 01 appears, turn ignition off.



Jul 24, 2009 | Volkswagen Golf Cars & Trucks

3 Answers

How to get rid of ''Service Now''!


Note: the Service Reminder Indicator displays 3 messages: OEL, IN 01, and IN 02. These display to alert the driver to follow the items listed under the manufacturer's service interval. To reset the message displays, turn the ignition switch on. Press and hold the odometer reset button "A" located below the speedometer. Turn off the ignition while holding the button. "OEL" will display on the indicator. Press and hold the lower digital clock reset button "B" until five dashes appear in the display. If needed, press the odometer reset button until "IN 01" appears and then press the clock reset button until five dashes appear. If needed, press the odometer reset button until "IN 02" is displayed and then press the clock reset button until five dashes appear. To exit reset mode, turn the ignition switch on and when "IN 01" appears, turn the ignition switch off

Apr 02, 2009 | 2004 Volkswagen Golf

1 Answer

How to i turn off the service now light on a 03 vw golf


To reset the message displays, turn the ignition switch on. Press and hold the odometer reset button "A" located below the speedometer. Turn off the ignition while holding the button. "OEL" will display on the indicator. Press and hold the lower digital clock reset button "B" until five dashes appear in the display. If needed, press the odometer reset button until "IN 01" appears and then press the clock reset button until five dashes appear. If needed, press the odometer reset button until "IN 02" is displayed and then press the clock reset button until five dashes appear. To exit reset mode, turn the ignition switch on and when "IN 01" appears, turn the ignition switch off.



1. Switch ignition ON.
2. Press and hold odometer reset button below speedometer.
3. Switch ignition OFF and release odometer reset button. OEL will now
display.
4. Press and hold the lower digital clock set button or the analog clock set
button until five dashes (-----) appear in display.
5. If necessary, pree odometer reset button to proceed to the IN 01 display
(15,000 mile maintenence) and reset using the clock button.
6. If necessary, repeat procedure to reset IN 02 (30,000 mile maintenence)
display.
7. To end reset mode: switch ignition ON; when display IN 01 appears, switch ignition OFF.

Thanks for using FixYa - a FixYa rating is appreciated for taking the time to answer your FREE question.

Mar 19, 2009 | 2000 Volkswagen Golf

3 Answers

Vw golf petrol 2.0 2001


Hi there,

There's one more thing you can try. On a Mk4 VW, you can reset the service indicator by doing the following:

- With the ignition off, press and hold the tripmeter reset button (on the right side of the dash)
- Turn on your ignition, wait for all the warning lights to come on, then let go of the tripmeter button
- Where your trip distance is normally shown, the display will read "OIL".
- To reset the service interval, turn the clock adjust switch (left side) for about 5 seconds. The trip meter display will change to "---" indicating the code has been reset.

You can verify this by turning the car off and on again. Let me know if that worked out for you.

Aug 11, 2008 | 2001 Volkswagen Golf

Not finding what you are looking for?
2002 Cadillac Seville Logo

Related Topics:

53 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...