How many rear wheel bearings are there on chevy equinox
SOURCE: removing rear break drum from a 2006 chevy Equinox
You need to de-adjust your rear brakes and/or slacken off the park brake cable to remove the drum as the chances are the drum has a wear lip that the shoes are getting hung up on. ( first make sure there isn't a little retaining screw holding the drum on !..visible with the wheel removed)
SOURCE: where and how to change cabin filter chevy equinox
Hiya...the cabin air filter is located below the front passenger/windshield area.
It's only accessible by standing outside the Equinox with the hood open.
Here's how to do it...(before you pop open the hood)
1) Stand outside at the front-right door area.
2) Just below the front windshield area, pull up a few small black plastic clips that's on the black windshield wiper cowl area- a small flat screwdriver or a special clip-remover tool is handy.
3) Raise the hood up.
4) There may be a triangular-shaped hard foam sound damper at the left side nearby the hood hinge...pull it off if it allow you to work around it with ease.
5) Continue to find a few black plastic clips around the black windshield wiper cowl area.
6) Gently pull up the black windshield wiper cowl cover with care not to bend it too hard during removal.
7) You should see the cabin air filter inside that's held in place by a black rectangular box inside.
8) There's 2 black tabs that holds the cabin air filter in place.
9) Insert your finger or tool to pry the cabin air filter away from the tabs.
10) Remove old cabin air filter.
Remember to reinstall the clip parts back into place when you're finished.
SOURCE: 2005 chevy equinox rear hatch not locking
I've had the exact opposite issue with my 2005 Equinox.
My rear door is locked and will not unlock.
SOURCE: 2005 equinox wheel bearing assy wont come out
okay i assume the rotor is off,remove the bolts out the back, take a hammer and beat the front of the hub the top then bottom then the sides to free,hit so that hub pull out,you will be hitting the back side the hub where the wheel would sit,if that doesnt work then use a chisel to break free, stick it where the hub meet spindle,ITs just frozen beat it.
Testimonial: "Thats awesome that someone would go to tjis much detail to help someone they dont know...thanks very much"
514 views
Usually answered in minutes!
×