Filter broke while coming off the transmission.
SOURCE: 1996 chevy lumina 3.4. service engine light on
You will need to replace the valve body in the transmission.
SOURCE: driver's seat in a 1998 chevy lumina has broken
so whats your question? Just unplug it from the harness, unbolt it from the floor panel, and make the switch, if your using another factory seat from the same year vehicle.
SOURCE: Do you have to remove the oil filter to replace
dont have to but alot easier to remove filter
SOURCE: how to remove a starter on 1993 chevy lumina?
Support the car very securely first of all
Remove the negative cable from the battery
Remove the wires from the starter
Remove the two bolts from the starter going upward to the engine block
Wiggle the starter out
Reverse this proceedure to reinstall
SOURCE: change the transmission filter and
Hello greenwave.
Here is the procedure for your job. Make sure when you lift the car it is supported safely.
Have a large area oil drain pan handy. It will take up to 5 or so quarts to refill. remember not to overfill, it's easier too add a little at a time than to take it out afterwards. Also remember that the fluid expands when it's hot so only go to the cold fill line when adding if it has one.
I generally just loosen the last bolt a little bit and let it drain slowly to avoid a mess.
Removal Procedure
Remove the oil pan (24) and gasket (25). Refer to Oil Pan Replacement.
If removed, install a new seal (101).
84 views
Usually answered in minutes!
×