Question about 2001 Daewoo Leganza

Open Question

Ok the crank sensor thats on the left side of the

Ok the crank sensor thats on the left side of the valve cover looks like its been tampered with..on my 01 DAEWOO LAGANZA

Posted by Arlene MGregor on

Ad

5 Related Answers

Anonymous

  • 1 Answer

SOURCE: serpitine belt for 1999 daewoo laganza diagram

1130.wmf link for similar diagram is here http://daewooautopartspr.com/_wsn/page15.html

Posted on Aug 28, 2008

Ad

Juan Guillen

  • 373 Answers

SOURCE: 2001 Daewoo Laganza Timing Marks

Hi...
On your request,
For the Crankshaft timing MARK.
You need to remove the cover, the Timing mark is inside.
Your Information is right.
The cam's at 12 O clock. Remember the left side Intake and the right side Exhaust.
Because each of the Cam sproket have the sign , Intake and exhaust

Ok. I hope this help on your question.
I have Pictures of all the marks. But to send you pictures I need any E-MAIL adress.
Because this site don't let me send more than 150kb. and the pictures are around 250kb.

Thank you for use fixya...


Posted on Oct 28, 2008

Ad

Anonymous

  • 5 Answers

SOURCE: locating camshaft positioning sensor on 2000 Daewoo Laganza

when you open your hood and you look on the valve cover you see on your left side of top of your cover a cable sticking out from a black piece that is the positioning sensor that cranksup the car

Posted on Mar 03, 2009

Anonymous

  • 219 Answers

SOURCE: locating camshaft positioning sensor on 2000 Daewoo Laganza

hi,
it is under the upper timing belt cover between the camshaft gears. According to the manual touching anything related to timing belt requires removing million parts including right front wheel. I suspect this might be an overkill just to remove upper timing belt cover.

So my advice would be to get it done by some mechanic as u will not be able to do it and may damage other parts also.

Thanks!
Sandy

Posted on May 18, 2009

Anonymous

  • 36 Answers

SOURCE: how tight to tighten valve cover

I highly recommend you buy a Hanes/Chilton manual for your make and model of car. The manual will tell you inch pounds and torque sequence for tightening the vale cover back on. Usually the sequence works from the center and works it way to the outside bolts. Please rate this reply if you found this helpful.

Posted on May 29, 2009

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2000 daewoo matiz . i need to find cam sensor on it. There are 2 sensors on the distributor housing is it possible that one is the cam sensor. 1 has one wire the other has 2.


I am going to assume you have the 1.6l engine because it is a pretty common engine for Daewoo. I had a 2000 Daewoo Lanos with a 1.6L engine. It has been quite some time since I had the vehicle but the cam position sensor was easy to replace. If you remove the plastic engine cover, then remove the valve cover, you will notice that on the left side of the cams near the timing belt that the sensor sticks up slightly and you can see the electrical connection to the sensor. I do not remember if I had to remove the timing belt cover or not but I don't think I had to. If I remember right, it was either one or two screws holding the sensor in place.

Oct 28, 2017 | Daewoo Cars & Trucks

1 Answer

I have a 2001 daewoo laganza that has a cylinder 3 missfire. I have changed the plugs and wires, but the car still gets horrible gas mileage and is still missfiring. Car runs like **** up until I get it to...


My 2001 Daewoo Laganza also showed this problem. It turned out that my valve cover gasket was
not seated properly and oil was accumulating around the spark plug of the #3 cylinder. Replaced gasket and engine started running fine.

Dec 03, 2010 | 2001 Daewoo Leganza

2 Answers

Laganza wont fire or pulse injectors


Check the timing belt which might be broken--if so, there will be severe valve and piston damage to cope with. If the belt is intact, then you may have a bad crankshaft or camshaft sensor, either of which will cause loss of ignition and injector action. Good luck!

Feb 18, 2010 | 2002 Daewoo Leganza

1 Answer

Where is the fuse for the horn in a daewoo laganza?


Fuse box is located under dash on left side. Slide the cover open. Diagram of fuses is on the inside of the panel door

Feb 02, 2010 | 2000 Daewoo Leganza

1 Answer

2000 Daewoo Laganza check engine light on had it check, it said cam sensor


camshaft position sensor is covered (still) by recall. I just had mine done, so its still covered. Request a recall packet from daewoousa.com. Nice folks

Jun 15, 2009 | 2000 Daewoo Lanos

1 Answer

Locating camshaft positioning sensor on 2000 Daewoo Laganza


hi,
it is under the upper timing belt cover between the camshaft gears. According to the manual touching anything related to timing belt requires removing million parts including right front wheel. I suspect this might be an overkill just to remove upper timing belt cover.

So my advice would be to get it done by some mechanic as u will not be able to do it and may damage other parts also.

Thanks!
Sandy

May 18, 2009 | 2000 Daewoo Lanos

1 Answer

Locating camshaft positioning sensor on 2000 Daewoo Laganza


when you open your hood and you look on the valve cover you see on your left side of top of your cover a cable sticking out from a black piece that is the positioning sensor that cranksup the car

Mar 03, 2009 | 2000 Daewoo Lanos

1 Answer

2000 daewoo Laganza no compression


valves bent sorry for the bads news

Dec 15, 2008 | 1998 Ford Escort

1 Answer

2001 Daewoo Laganza Timing Marks


Hi...
On your request,
For the Crankshaft timing MARK.
You need to remove the cover, the Timing mark is inside.
Your Information is right.
The cam's at 12 O clock. Remember the left side Intake and the right side Exhaust.
Because each of the Cam sproket have the sign , Intake and exhaust

Ok. I hope this help on your question.
I have Pictures of all the marks. But to send you pictures I need any E-MAIL adress.
Because this site don't let me send more than 150kb. and the pictures are around 250kb.

Thank you for use fixya...


Oct 26, 2008 | 2001 Daewoo Leganza

Not finding what you are looking for?
2001 Daewoo Leganza Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top Daewoo Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

john h

Level 3 Expert

23515 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14852 Answers

Are you a Daewoo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...