Which ENGINE, there are 5
ill guess...6.1L
what are, ?
are you asking for the full list of codes related, to 02,
all including lazy CAT?
never ever seen a post like this on any forum for any car.
this is unique, request.
well you can read the FSM just like us.
why not do that.
my FSM is 7000 pages long and those are all dispersed there.
ill try alldata.com
and RTM. online.,
p013a &c
1196
014x
05x
06x
07x , ok i give up you can read the 7000 pages, just like me.
lots more.
what's the point?
SOURCE: Jeep Hesitates. P0303 code
Check the cylinders Commpression. over 115 psi is good, 120 psi is normal.
SOURCE: location of crankshaft position sensor Jeep grand cherokee 1997
left rear of engine block,on transmission bell housing.best way from top under brake booster use a wrench,
SOURCE: where to replace coolant temp sensor for 1998 grand jeep cherokee
Check this image...
...in the Section ZJ-Secc-8D-Ignition-Systems (page 5, fig. 10 and 11).
Good luck.
SOURCE: Where is the camshaft sensor located on my 99 Jeep Grand Cherokee
If you still have a cap rotor and ignition wires, it's inside the distributor. If not, it is the part where the distributor used to be (center rear of the engine behind the intake manifold)
SOURCE: location of cam sensor 2003 jeep grand cherokee v8
Answer
pic
REMOVAL - 4.7L
The Camshaft Position Sensor (CMP) on the 4.7L V–8 engine is bolted to the front/top of the right cylinder head (CMP Location—4.7L Engine).
It is easier to remove/install sensor from under vehicle.
Raise and support vehicle.
Disconnect electrical connector at CMP sensor (CMP Location—4.7L Engine).
Remove sensor mounting bolt (CMP Location—4.7L Engine).
Carefully twist sensor from cylinder head.
Check condition of sensor o-ring.
See picture for sensor location.
Testimonial: "that is just what i needed thanks"
115 views
Usually answered in minutes!
×