Cars & Trucks Logo

Related Topics:

A
Anonymous Posted on Sep 06, 2014

<!-- from fixya rte -->How to turn off abs light on jaguar xk8 - XK8 Jaguar Cars & Trucks

1 Answer

Marvin

Level 3:

An expert who has achieved level 3 by getting 1000 points

Top Expert:

An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

  • Jaguar Master 85,242 Answers
  • Posted on Jun 18, 2017
Marvin
Jaguar Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Top Expert:

An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

Joined: Jun 20, 2008
Answers
85242
Questions
28
Helped
29037716
Points
266281

The light will go off only when the fault in the ABS system has been repaired.

5 Related Answers

bobvallom

  • 5 Answers
  • Posted on Nov 24, 2008

SOURCE: Adding coolant to a 1998 Jaguar XK8

if the coolant light is on or comes on when driving you MUST let the car cool down at lest 1 hour before doing anything, after this cool down time lift the hood [u.s.a.] or bonnet [uk] looking from the front of the car on the right hand side towards the back of the engine compartment is the coolant header tank,about 5inch square black in color [u.s.a.] colour [uk] with a large screw top and some rubber pipes coming from it,this should be topped up with coolant right to the neck of the screw cap when you remove the cap to top up the coolant unscrew it slowly as it may be under pressure you don't want hot 212F[u.s.a.] 100C [uk] coolant in your face do you.good luck.

Ad

Anonymous

  • 16 Answers
  • Posted on Jan 30, 2009

SOURCE: need to install radio antenna on 1999 jaguar xk8

on the base of the antenna mast is a chrome nut (14mm?) unsrew that, then turn radio on , it will eject the guide cable. then insert the new cable, turn radio off and wait like 15sec then the motor will take in the new cable then put the chrome nut back on> thats it

Anonymous

  • 837 Answers
  • Posted on Mar 24, 2009

SOURCE: I need serpentine belt routing for 1999 Jaguar XK8

This is a view of the correct belt routing ..

bb09405.jpg

Anonymous

  • 4 Answers
  • Posted on Apr 26, 2009

SOURCE: i want to clear check engine light on 2002 jaguar xk8

go to autozone have them scan it and then clear it record the trouble code and then clear it another option is disconnect the battery both positive and negative and make a jumper wire between the 2 terminals make sure that you disconect the battery very importan

Anonymous

  • 2 Answers
  • Posted on Jul 27, 2009

SOURCE: jaguar XK8 PROBLEM BOOT WON'T CLOSE

In the trunk on the right side behind the carpet is the hyrdaulic unit. There is a T fitting on it. Turn the T fitting counterclockwise to release pressure. Tighten it back up and try the top again. I have had this work for me several times.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer
0helpful
1answer

I have a 1998 jaguar xj8 i changed the steering wheel knuckle abs ring break pads caliper and now the abs sign is on?

Did you turn the key on at any time when the wheelspeed sensor (this is what detects the rotation of the "ABS ring") was disconnected? You may have to interrogate the ABS controller with a diagnostic computer to read the diagnostic trouble codes and then clear them. Also, you may have to drive the car 10km per hour for a few moments after the codes are cleared to get the light to go out.
0helpful
1answer

I HAVE A 1998 JAGUAR XK8, BAD COIL BUT NO ENGINE LIGHT

could just be a vacuum leak or the throttle plates are dirty
3helpful
2answers

Can't find in manual "ASC' trouble

ASC is short for "automatic stability control" u will need to have the ABS/Traction control system tested by the dealer for a possiable fault code.
0helpful
1answer

I have the same problem on my 1998 XK8

Seek the Jag-Lovers.com website for Dan Jensen's article on repairing the ABS Electronic control board (seems a solder joint becomes intermittent). This is a common trouble in XK8s... mine needed to be replaced recently too....

Best regards,
Michael
1helpful
1answer

I want to clear check engine light on 2002 jaguar xk8

go to autozone have them scan it and then clear it record the trouble code and then clear it another option is disconnect the battery both positive and negative and make a jumper wire between the 2 terminals make sure that you disconect the battery very importan
0helpful
1answer

Jaguar xk8 auto, won't come out of park

your brake switch, the one that activates rear brake lights has probably failed. Press brakes, have someone see if brake lights turn on, if no then it is a brake light switch problem.
5helpful
4answers

XK8 abs module

We have the same problem with our BMW. Dealer quoted close to $1500, with a one year parts warranty. Go to Module Masters at www.modulemasters.com.

They show detailed info on how to remove your unit, and will rebuild one for a 2001 XK8 for $150. The unit for our BMW is $300.

I have heard great comments about Module Masters. Well worth a shot!
Not finding what you are looking for?

443 views

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...