Question about 1994 Dodge Caravan

Open Question

How do you uninstall ignition switch safely in a 1994 Dodge Caravan?

Posted by Anonymous on


5 Related Answers


Mike Butler

  • 6674 Answers

SOURCE: Bell on ignition switch does not stop ringing on 1999 Dodge Caravan.

Locate it by sound & pull it out, and replace it. probably stuck relay inside it.

Posted on Nov 29, 2008


robert kious

  • 58 Answers

SOURCE: Dodge Caravan radio won't work

you need to check fuses on the drivers side dash panel. look for the iod fuse may be 2 unplugg the iod fuse then plug it back in

Posted on Jan 27, 2009



  • 448 Answers

SOURCE: Tested each spark plug on my 94 Dodge Caravan and it has no spark

Your likelihood that it was your coil in the first place was slim. First thing to check is your fuel pressure. Not enough fuel pressure, your ECM won't let your coil fire.

Posted on Mar 23, 2009


  • 396 Answers

SOURCE: 1994 Dodge Caravan driver's window won't close.

Start by removing the plastic insert at the door handle. This can be pried out with a screw driver, remove the door handle, prior out the plastic tabs, remove the screws there will be approximately four or five screws, lift the panel up and pull awar from the door. Remove the door regulator, you do this by using a punch and pundh out the rivets, then you drill out the aluminum holding in the glass using 1/4 inch drill bit, remove the door regulator and check for damage, you also need to remove the door motor and take it apart. The door motor will have three plastic plugs in the motor remove these, you can purchase new plugs at any auto store for $8.51, howevwer I would recommend you replace with ball bearings which can be purchased for $.64 cents each at any hardware store, pack the motor with wheel bearing grease and replace. You will need 1/4 inch bolts and lock washweer and nuts to replace the door regulator. Normally the switch will not be the problem. I would recommend you replace all the door regulators and rebuild all the motors. If one is going bad the others will follow. Expect to take allday to complete the job. Door regulators can be purchased on line for around $18 to 30 dollars. Good luck.

Posted on Jul 13, 2009

Patrick Rayome

  • 1757 Answers

SOURCE: Need serpentine belt routing diagram for 1994 Dodge grand caravan

Looking at the engine from front (right side of the Van): Stating at the Top, Going Left to Right and Clockwise:
Over the Alternator
To under the Idle Pulley,
To Over the AC Compressor.
To the Left Side of the Water Pump.
To the Right side and Under the Crankshaft Pulley
To the Right side and Over and Down the Tensioner
To Under the Power Steering Pump
And Back up-to the Left side of the Alternator.
Advise when puting it on:
Put the Belt around everything else accept for the Alternator. After it is around all the rest of the Pulleys - Pull the belt up - tight from the Power steering Pump and the Idle Pulley to form a loop, holding the Belt close to the Altenator Pulley.
Using the 15mm wrench or belt tensioner bar - rotate the Tensioner Pulley towards the front of the Van and then place the belt over the Alternator.
Let me know if this helped or if you have additional information or questions. Feel free to contact me at!

Posted on Jan 22, 2010

Add Your Answer


Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How do I safely remove an igniton switch?

Make sure the battery is disconnected and the airbag.

Sep 03, 2014 | 1994 Dodge Caravan

1 Answer

I have a 94 dodge caravan it idles fine but it is running rough engine codes I picked up are 12 and 41 and 55 do you know what these codes are. Thank You

12-direct battery input to PCM was disconnected within the last 50 key-on cycles
41-generator field not switching properly
55-end of error messages
Check sparg plugs, ignition cables, fuel system (fuel filter, injectors)

Oct 31, 2009 | 1994 Dodge Caravan

2 Answers

I have a 1994 dodge caraven se the heater switch worked fine in all three setings then the low and med stoped working it still works on hi what could be wrong?


Aug 03, 2009 | 1994 Dodge Caravan

1 Answer

Tested each spark plug on my 94 Dodge Caravan and it has no spark

Your likelihood that it was your coil in the first place was slim. First thing to check is your fuel pressure. Not enough fuel pressure, your ECM won't let your coil fire.

Mar 23, 2009 | 1994 Dodge Caravan

1 Answer

Replace front struts 1994 Dodge Grand Caravan

your on the right track. it can't be done with out a spring compressor. but do you purchase a GOOD
SAFE compressor for a few uses ?. better to unbolt the three top 13 mm retainer nuts ,than unbolt the two 21 mm lower steering knuckle bolts along with the 15mm stabilizer nuts, and take the strut to a local garage and pay a couple of bucks and have someone pressthe spring on thier compressor for you . its safer. also index the lower 21 mm knuckle bolts for reassemble. its your wheel alingment camber angles.
good luck chris

Mar 14, 2009 | 1994 Dodge Grand Caravan

1 Answer

Ignition swich lock cylinder replacement on a 1994 grand caravan

take it in ahve the keyways switched! i did that before!

Dec 18, 2008 | 1994 Dodge Caravan

Not finding what you are looking for?
1994 Dodge Caravan Logo

Related Topics:

43 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

85239 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14850 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides