With a socket + universal and an extension?
you dont have full tools set?
which engine,? gas or diesel? 3.8L
my 2008 6speed, is yours 5 m.t or slush pump.>? a/t
on mine, its easy.
but cant answer with no engine stated or trans.
or car bodies are same ,for sure. 2door.? right>?
mine is 3.8L v6
i own a full FSM. too.
7400 pages.
the books shows removing battery neg lug, or boom.acid bath
then shield
then says remove starter. see the bolts there?
then as it drops down take of the solenoid wires.
its you hands.
it assumes you have full set of tools.
extensions, universals., and sockets.
but no engine options stated.or transmission.
SOURCE: 2007 jeep wrangler sahara with a mopar remote starter just beeps
That's not a remote starter on your key chain, it's a keyless entry for an alarm system.
SOURCE: 1997 wrangler starter removal
alot of the time the line up dowels rust into the block. usually soaking where the starter meets the block with a rust penetrant and wiggling the starter around does the trick
SOURCE: how to change starter on 1994 jeep wrangler
is it the straight six? if so first disconnect the battery then there should be 2 bolt 13 or 14 mm. take wires off. then reverse for install.
SOURCE: how do i remove a starter from a 1995 jeep wrangler
Raise vehicle, disconnect negative battery cable. remove two nuts and wires holding cables with approx 3/8 socket. It will probably be metric.
Then remove two retaining bolts holding starter. remove starter
Reverse procedure to reinstall.
For more information you can view your free online repair manual at;
http://www.autozone.com
http://www.autozone.com/autozone/repairinfo/common/repairInfoMain.jsp?targetPage=productsHowToInspect&leftNavPage=productsHowTo&pageId=%0900045_starterreplace.xml&subtitle=replace
SOURCE: Removing doors from Jeep Wrangler - Dome Light Stays On
I have a 97, and my fuse for that is behind the glovebox. Open the box, slide the end of the strap to disconnect it, then remove the box. The fuse is marked. Something like "Dome lt. elim." I think it's located one up from the bottom right. This can actually be done without removing the glove box. For a more permanent fix, quadratec.com has a switch that plugs into the fuse location and mounts under the dash, so you can just flip the switch. Hope this helps.
428 views
Usually answered in minutes!
×