Turned on the key and nothing. Charged the battery three days ago, started fine. And it appears the nothing works. Checked the battery it's hold its' charge. Is the cause a relay or somethig simple, or something more serious?
Replace the starter motor when you have voltage present at the single small wire that is connected to the starter motor, when the key is turned to start position . this can be checked by disconnecting the gray connector near the starter motor and check it there on the wire harness side or by inserting a paper clip or t-pin slid along the wire into the connector to make contact with the terminal pin.
Please check all connections. Are lights/horn workings?
SOURCE: 2004 Nissan Maxima
it is a cable that links you transmision to the dashboard
i am not sure what the name of the cable is
but if you hold the start position and switch the gears to neutral it will start.
SOURCE: 2001 Nissan Fronteir Crew Cab -- Ignition/electrical issue
it sounds like you have a braker going bad and it just went out the rest of the way...so if you can find the cicret braker that went out and replace it the truck should work fine....or it could be a relay that went out....try this and let me know...good luck..
SOURCE: 2003 Nissan Sentra won't start
I had this problem recently ie no start on key & found bad earth to engine was cause.
Not my AOE but may be a possibility.
Will eliminate if nothing else.
SOURCE: 1987 nissan pathfinder has almost no power.bad relay?
first u need to check if they did any welding to ur car if so did they disconnect the battery if not then whoever did ur muffler probally ower u a new computer for ur car
215 views
Usually answered in minutes!
Bummer mystery. Battery post or cable being dirty may be the cause. The fix is to remove and clean post and cables. Take the smaller black "ground" cable off first, and install it on last.- Got That? Part stores sell a tool just to clean these parts [cost $5]. If battery is dirty, wash with dish soapy water. rinse off with water. Sprinkle baking soda on connectors, then remove and clean them. Follow ground cable and tighten its connection to the motor and frame. A good time for tune up additives to be installed. Hope this helps. Tips on additives here :https://www.auto-tune-up-and-repair-opti...
×