289 cubic inch/ 2 barrel
SOURCE: Size of valve springs fo 289 ford engine with 302 heads
its not that easy here are some of the things u need to know
* solid or hyd cam
* roller or flat tappet
* valve installed hieght
* rocker ratio
* cam lift
this is just a few things go to a head shop and they will choose the right ones
SOURCE: firing order for 1966 ford mustang 200 cubic inch
The engine is a 200 CID straight six, the firing order is 153624...
Just pop the distributor cap and have someone crank the engine while you
watch the rotor.
How I can determine which hole in the distributor is assigned to the #1
plug wire.
Pull the number one plug. Turn the engine over slowly (with a wrench)
while holding your finger over the plug hole. When the air builds (a lot
of) pressure you are coming up to the number one spot on the
distributor. (the rotor will point to the location of the #1 hole in the
distributor.)
Quick methods to disable the engine I have seen people do on the
classics:
Close the points by loosening the set screw
Pull the rotor cap
Connect a wire from the coil to ground. (effectively closes the points.
Can damage the coil if key is left on.)
Pull the main ignition wire
And there are some tricks at the starter solonoid involving the ballast
resistor bypass that is used to provide a hotter spark while cranking.
(Two little wires at the starter solonoid - one is crank the other is
the ballast bypass.)
Might give those a look-see. Best of luck (rememeber rated this help).
Testimonial: "This has been very helpful!! Thank you!"
SOURCE: firing order diagram for a 289 motor
Firing Order: 1-5-4-2-6-3-7-8
Distributor Rotates Counter-Clockwise
SOURCE: distributor cap firing order 5.0 engine , wiring
1995 Ford F 150 Pickup 5.0 liter V-8 VIN "N"
I hope helps (remember to rate this).
1-5-3-6-2-4 is the spark plug firing order for the 4.9 L ( 300 cubic inch ) straight 6
The distributor rotor turns CLOCKWISE
The marked # 1 position on the distributor cap is installed facing away from the engine
Hope this helps
472 views
Usually answered in minutes!
×