SOURCE: 1995 buick regal
hi is it automatic and won,t start that mean won,t turn over or turns over but won,t start ? how occasional yates210456
SOURCE: 1999 Buick regal Security light on. Won't start.
I had the same problem with my 95 Lesabre. The owners manual says to take the key out, and wait 3 minutes(until the light goes off). It should fire right up.
SOURCE: signal bulb on 2003 buick regal
To change front turn signal –
open the hood; look in back of headlight; two white clips; pull straight up, and then whole headlight comes out including turn signal; it is all one unit; remove rubber cover, then you take bulb out of unit. Mechanism that bulb fits in will need to be turned clockwise (looking from the front) and pulled to get it out of the larger unit holding all lights. Be sure and put rubber cover back on before re-inserting the two white clips.
SOURCE: How do I replace a starter in a 2000 Buick regal
The starter is on the underside of the transmission, there are wires feeding the solenoid (remove) 3 starter bolts (remove) pull off transmission/flywheel
SOURCE: how do i remove the starter?
Removal
1. Disconnect negative battery cable. Raise and support vehicle. As required, remove nuts from A/C
compressor, exhaust system and/or engine braces, adjacent to starter. On M/T models, remove bending
brace from around starter (if equipped). On all models, remove other items that may interfere with
removal of starter.
2. If necessary, remove nut from engine cross brace. Using pry bar between upper engine mount and engine,
pry rearward and support engine.
3. If necessary, remove oil filter, air induction tube and cooling fan. Remove flywheel inspection cover (if
equipped). Remove starter solenoid terminal "S" nut and battery cable nut. Separate wiring from starter.
Remove starter mounting bolts. Remove shims and note arrangement for reassembly. Remove starter.
Installation
Before installing starter onto engine, tighten inner solenoid terminal nuts to ensure they are secure in cap.
Starter failure may occur due to terminal or cap damage. Install starter and wiring. Ensure shims are installed in
original location.
164 views
Usually answered in minutes!
×