Tappet specs
SOURCE: Kia Rio 2002 - Car not response when press gas
can anyone tell me how to change the time belt on my kia rio cinco
SOURCE: resetting airbag on 2002 kia rio
Typical code readers (OBDII) won't touch the airbag lights. Neither will disconnecting the battery and waiting. If the airbag light is flashing, there's a code involved. The system may or may not work when needed. If it's on steady, the system is failed and will not deploy when needed. Typically, it's a connector in the various harnesses involved. Unfortunately, the Kia shop manuals just say "replace everything" so they're no help. The dealer has the very expensive code reader to read & reset the airbag light. In other words, $$$.
SOURCE: what is the proper spark plug gap setting for a 2002 Kia Rio
Hello mfriesner71; my name is Roger and I will answer for you. The correct plug gap is 0.027 to 0.031.in. Any gap between these will work fine. Just make sure they all gap the same. Should you need further help please just ask. Please rate the answer. This way I know it was helpful. Thank You for using Fix Ya. Roger
SOURCE: what is a kia rio p1800 error code mean?
P1800
Engine torque signal malfunction
Threshold Value ~ Circuit continuity: Open or shorted
Enable Conditions ~ NA
Time Requirements ~ Continuous
MIL Illumination ~ No MIL illumination
Related Items
1)Open between TCM (C221-41) and ECM (C254-68).
2)Short to B+ or GND between C221-41 and C254-68.
STEP
INSPECTION
Y/N
ACTION
1
With ignition off, disconnect C254 from ECM and C221 from TCM. Measure resistance between C221-41 and C254-68 (less than 1 ohm).
Is resistance as specified?
YES
Go to step 2.
NO
Locate source of open or high resistance and repair as necessary.
2
Measure resistance between C254-68 and GND (infinite resistance).
Is resistance as specified?
YES
Go to step 3.
NO
Locate source of short to GND and repair as necessary.
3
Turn ignition on and measure voltage at C254-68 (0v).
Is voltage as specified?
YES
Thoroughly check for loose, bent or corroded terminals in circuit than go to step 4.
NO
Locate source of short to B+ and repair as necessary.
4
Clear codes and return vehicle to original condition. Verify any repairs by driving vehicle with KIA Data Pro connected to OBD-II connector and monitoring for pending codes (refer to section 3 of the KIA Data Pro Generic OBD-II Program Card reference manual).
If you need further help, reach me via phone at https://www.6ya.com/expert/joel_63c670a84e9f6a97
42 views
Usually answered in minutes!
×