Question about 2003 GMC Yukon Denali
Posted by Anonymous on
There are 2 fuse panels in the Denali.
One is a panel on the drivers side, its on the dash but facing the door.
The ohter is under the dash and above the pedals, this one is much tougher to access.
Your Owner's Manual should tell you where the fuses are that you need to access.
Posted on Oct 20, 2008
There's a lever that connects the driver-side rear shock to the Automatic Level Control module (the air compressor and the ride-height sensor). Disconnect the lever from the shock and rotate it up and hold it. The compressor should kick in when you hold in place after a few seconds. If it doesn't kick in, make sure your fuses and relays are good. Otherwise, you may have a failed ALC module/burned out air compressor (from the shocks being shot). After you replace the shocks (and after you recouped from the heart attack you had when you shelled out $500+ for each shock), replace the ALC module/compressor (it's all one unit), and test it - it should kick on when you rotate the lever up again.
Figure about $350 for the ALC module from your dealer, and make sure the part numbers match! Your truck came with an upgraded ALC module from the 2001-2004 module, which were prone to water damage.
Posted on Dec 30, 2008
hi for info the brakes warning light on dash is also an indication that brake fluid level is low? or there may be a leak resulting in fluid level drop ? also considering age of car you may need to inspect brake pads wear ? if your car has low brake pads wear indicators attached to pads ? or the hand brake switch req's checking to ensure it is being pushed to off position when h/brak is down ? so fluid level low is the obviouse 1st check as fluid will displace from reservoir as pads wear low hence the level indicator on fill cap trips on may i suggest if it is low level b4 you top up? check your b/pads if you have not done so recently? or replaced since new ? hope this helps you locate problem best wishes from the uk
Posted on Jan 03, 2009
it has to do with your air ride suspension best bet is take it to the dealer there is probably a problem with a level sensor. hope this helps you
Posted on Mar 16, 2009
Your sending unit for the guage is part of your fuel pump in the tank. But first try your fuel pump relay, may be working intermittenly when you hit a bump or something. Or possibly a loose wire somewhere along the way. Much less expensive (worth a look).
Posted on Dec 18, 2009
Tips for a great answer:
Apr 12, 2018 | 2003 GMC Yukon Denali
Sep 20, 2016 | 2007 GMC Yukon XL Denali
Dec 20, 2014 | 2003 GMC Yukon Denali
Feb 15, 2013 | 2007 GMC Yukon XL Denali
May 16, 2011 | 2003 GMC Yukon XL
Feb 09, 2011 | 2003 GMC Yukon Denali
Oct 03, 2010 | 2006 GMC Yukon Xl Denali
Jun 11, 2010 | 2003 GMC Yukon Denali
May 13, 2009 | 2003 GMC Yukon
Mar 11, 2009 | 2003 GMC Yukon Denali
49 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: