How do you remove a bumper off a 1999 trooper

No, you don't have to remove any thing from the inside. Inner fender covers have to come off. Then the rest are plastic plugs..

about four and a half

how to bypass/remove immobiliser

The procedure to replace radiator on 1999 VW Jetta is as follows:--- **Locate and remove the drain plug on the bottom of the radiator, and let the engine coolant drain into a resealable container. Then unplug the electrical connectors from the coolant fan and thermal switch.
**Then carefully detach the release lever holding the front bumper, and take off the radiator grille. Remove all bolts holding the front bumper and take off the bumper. Disconnect the temperature sensor connector and if necessary remove the spoiler.
**: Unhook the quick release couplings holding the coolant hoses to the radiator. Removing the screws securing the headlights and disconnect the headlights. If your Jetta is equipped with A/C, unfasten the A/C mounting bolts and the condenser bracket bolt on the left of the radiator.
**: Remove the radiator mounting bolts and slide the radiator and fan by sliding them downward. Don't disconnect any refrigerant lines, if your Jetta has an air conditioning unit.
**: Take the retaining clamps off the refrigerant lines and remove the bolts securing the refrigerant line from the side of the radiator. Be very careful that no hoses or lines are stretched or bent. Swing the radiator down and remove it from the vehicle.
**: Replace the radiator and replace and reconnect all engine and electrical components and the fender and bumper in the reverse order.
**: Then carefully fill the radiator with a mixture of half distilled water and half engine coolant. Start the vehicle and let it run for few minutes with the radiator cap off, in order to bleed air from the lines. Check the fluid level and top it off if necessary, then put on the radiator cap. ------Its done.

Thanks. keep updated for any more query.you can rate this solution and show your appreciation.

The easy way is to take the inner boot off and take the joint apart. Take new cv axle apart at inner joint and attach to the old one sticking out of axle housing. You will need to get new boot clamp.

Bolted on to the chassis same bolts as the towbar so if a towdar is fitted then you will have to remove both.

Guess that would be an external TORX then , be about a T40 - 45 size .

must remove clips from inside front axle housing!! If the cv joint aint broke DONT FIX IT the boots can be replaced in less than 1 hour with hand tools and the boot is around 20$ at any parts store

not very simple without proper tools. The are bolts on each side of the core support. slide pins are inserted when the first bolts are removed then the reste of the bolts are removed. This allows the entire bumper and core assembly to slide forward and give the space required to remove the fan. The fan removal is pretty simple at this point. once replaced the bumpers slides back into position and the bolts are retightened

7/16th or 10mm Sheetmetal nuts All over Behind the Bumper Thak Bumper off first