Question about 1998 Isuzu Trooper

1 Answer

Why does my Trooper take 30 minutes to warm up before intermittent power surging and panel lights blinking stops?

Three lights blink intermittently: the four wheel drive icon light, the ABS system light and the battery light. Usually in three-blink increments.

Posted by Richard Roy on

Ad

1 Answer

Charles McElchar

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 389 Answers

Need to know more. Is it petrol or diesel. If diesel is it the 3.1 or 3.0. Isuzu changed engines that year (1998) from 3.1 to 3.0 common rail.

Posted on Aug 11, 2014

Ad

5 Related Answers

Anonymous

  • 5 Answers

SOURCE: 1996 Isuzu Trooper ABS and All Wheel Drive light on

Its a mechanical problem related to transmission.You should start from there.

Posted on Feb 13, 2009

Ad
stevenhurc

Steve Hurc

  • 459 Answers

SOURCE: Three fuel pumps have failed in the past four

do an ohms test on wiring loom if any higher than approx 5ohms when everything is disconnected bad connection. this can still show good voltage but pump not getting enogh amps(current) so it burns out windings in pump
are old pumps open circuit?
test with ohms meter
if so check that wiring and connector pin tensions

Posted on Jul 02, 2009

kayzack519

Jason Conway

  • 226 Answers

SOURCE: I have 2001 isuzu rodeo that the four wheel drive

fords are famous for this. Its electronically controlled 4x4(push button) i would start cheap and replace that switch

Posted on Dec 08, 2009

simontricket

Simon

  • 235 Answers

SOURCE: 2002 ISUZU TROOPER PROCEDURES TO OPERATE THE FOUR WHEEL ENGAGING

Just press the 4wd button on the dash at any speed up to about 40mph and press again to come out .
When you turn the key on and the oil and battery lights are on the little green 4wd light should be on too if its flashing or not on check your fuses in the drivers footwell.

Posted on Dec 25, 2009

riceski

Gary Rice

  • 1851 Answers

SOURCE: I have a 99 isuzu trooper (jackaroo) 3.5 liter 4wd

sounds like a sensor - when did it start - if just cranked up one day and bam it is there - sounds like either a brake wear indicator issue - if they are connected in those - or a fluid level change in the rear end or transfer case - look for leaks and check the brake pads or shoes

Posted on Dec 26, 2009

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2005 Chrysler Sebring started and turned off three times now, it just has a blinking red light?


Anti-Lock Warning Light (ABS) - If Equipped This light monitors the Anti-Lock Brake System (ABS) described elsewhere in this manual. This light will come on when the ignition key is turned to the ON position and may stay on for as long as four seconds. If the ABS light remains on or comes on during driving, it indicates that the Anti-Lock portion of the brake system is not functioning and that service is required, however, the conventional brake system will continue to operate normally provided that the BRAKE warning light is not on. If the ABS light is on, the brake system should be serviced as soon as possible to restore the benefit of Anti-Lock Brakes. 24 7 Locksmith Orchard Park NY 716 710 7400 Locksmith Orchard Park NY

Aug 11, 2016 | Chrysler Sebring Cars & Trucks

1 Answer

What is wrong with my 1998 Trooper when cold it powers down, three lights blink intermitantly(ABS, Battery, & Four wheel drive), all until it is completely warmed up?


Ask at the dealer here as i have a feeling that this vehicle will have encrypted software if it was made for the europeon market ,could be a component fault in the computer which is my first suspicion ,then it could be a dirty ground or earth cable ,difficult to pinpoint with having vehicle in front of me

Jul 24, 2014 | 1998 Isuzu Trooper

1 Answer

ABS LIGHT IS ON WONT GO IN TO FOUR WHEEL DRIVE


Check with a code reader or scanner, the ABS could be at fault

Mar 24, 2013 | 2005 Nissan Frontier

1 Answer

Low traction light sometimes comes on.Weeks go by and it doesnot come on .Then all of a sudden low traction appears again


I have three 1997 Olds Cutlass's. They do it to! Nothing to worry about. They will do that in response to a bump, or washboard road driven over at a certain speed. The wheel speed sensor on each wheel tells the computer how fast each wheel is turning. If one wheel speed is faster than the other three, as when you hit a bump, the computer thinks it is loosing traction and flashes the light, and may or may not engage the ABS system to even up the speed on all four wheels.

Now if that light comes on, and STAYS on, that is another matter. It will only do that if a wheel speed sensor becomes faulty, and then the ABS light will override the traction light.

Drive on!!!

Aug 29, 2011 | 1996 Chevrolet Cavalier

2 Answers

My 1997 Range Rover shows "gearbox failure, abs failure, and traction failure"


If you have a weak battery, change it, the electronics on a P38 are a nightmare,
I have had my share and still have them, good luck

Jul 29, 2010 | Cars & Trucks

3 Answers

Warning lights staying on after engine started


probably the shuttle valve in the ABS unit is defective, solution renew shuttle valve, dont let dealership sell you a new ABS unit very expensive

Mar 08, 2009 | 2000 Land Rover Discovery

1 Answer

1994 chevy s10 blazer 4x4 push button type


small sylinoid on the top of the transfer case needs replaced. easy to do. it has three vacumelines going to it just trun out and replace like a bolt.

Dec 10, 2008 | 1994 Chevrolet S-10 Blazer

2 Answers

ABS light on and 4x4 light is blinking


Have someone check the wheel speed sensors. One is probably bad and not sending data to the computer. This will shut off your ABS system and all-wheel drive, because the system can't read the speed of one of your wheels. It needs input from all 4 wheels for the systems to work.

Dec 07, 2008 | 2005 Ford Escape

1 Answer

ABS Light gives out three codes,Where can I get a list of codes to trouble shoot by?


Hi,

Most Honda ABS warning light will blink in 2 parts, main system and then sub system to form the code pair. As an example is 3 blinks then 3 blinks is a code 3-5. Once determined, reference below listing.
1 - ABS pump motor over-run
1 2 ABS pump motor
1 3 high pressure leakage
1 4 pressure switch
1 8 high pressure system
2 1 parking brake
3 1 pulser RF
3 2 pulser LF
3 4 pulser RR
3 8 pulser LR
3 12 different diameter tires
4 1 wheel sensor RF
4 2 wheel sensor LF
4 4 wheel sensor RR
4 8 wheel sensor LR
5 - rear wheel lock - R/L
5 4 rear wheel lock - R
5 8 rear wheel lock - L
6 - fail-safe relay - F/R
6 1 fail-safe relay - F
6 4 fail-safe relay - R
7 1 solenoid - RF
7 2 solenoid - LF
7 4 solenoid - R
8 1 ABS function
8 2 CPU comparison
8 4 IC self-check

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.

Thank you for using FixYa.

Jul 25, 2008 | Honda Accord Cars & Trucks

Not finding what you are looking for?
1998 Isuzu Trooper Logo

214 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14850 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...