I have a 2003 Pontiac Grand Am. When my lights are turned on, all my lights work. But when I apply the breaks my rear, riders side, brake lights do not light up. I replaced the bulbs and cleaned the connection. but didnt help. Why will they light but not brighten as brake is applied???? Please help
Gota be blown fuse some where
If you need further help, I’m available over the phone at https://www.6ya.com/expert/richard_b59056c0c62ecb00
Posted on Aug 07, 2014
SOURCE: rear brakes 1998 pontiac sunfire
disc brakes on back. sometimes they will stick until they get hot. sometimes will stick when they get wet. check to see about your anti brake locking system.
Posted on Jan 24, 2009
SOURCE: I have a 2001 Pontiac Montana. The driver side brake light melts
Make sure your useing the correct bulb and its pluged in the right way, if your sure of that, than check your ground a poor ground could do that, when there is a bad ground, it will travel thru the positive to find a ground maybe overloading it. There is a chanse it could be a bad break light switch. You can chk. that by applying the breaks for a little wile and let off and feel the switch and see if its excessively warm or hot.
Posted on Mar 19, 2009
SOURCE: 2000 pontiac emergency brake stuck. how do i
Are you in a Northern Climate were road salt is used during winter? The emergency brake problems I have encountered tend to be due to rust and corrosion accumulating on the wires and metal pivot points that operate the brake via the emergency handle on the center console.
Get underneath the car (chock the wheels---ALL FOUR! with bricks or large chunks of wood---be sure the car is in PARK!) and find the wire that connects to the handle of the brake---follow it to the rear brakes, and you will see a split where it goes to the L and R sides via a sliding clasp of steel that looks like a C, and has wires running over the top, and to each rear brake.
At this point, grab the wire on one side of it and PULL HARD several times, slack between pulls. Do this for each side---that should release the assembly, and the shoes from holding the drum.
After you have done this, lubricate the pivot points and the wire connection to the brake handle with TRI-FLOW (NOT WD-40)or another teflon based lubricant.
Posted on Mar 27, 2009
SOURCE: pontiac g6 sedan 06 model
2007 PONTIAC G6 CONVERT. BRAKE LIGHTS STAY ON WHILE DRIVING AND GO OFF WHEN PUT BRAKES ON, AND YOU CRUISE CONTROL WILL NOT WORK WHILE BRAKE LIGHTS ARE ON.
Posted on Jun 10, 2009
SOURCE: abs light and trac off light on
hey, ihad this problem with abx and trac off light on all the time even after having replaced the wheel bearing twiice. how i fixed it was to replace the wiring harness and poof issue resolved. a technical service bulletin is available for this issue
Posted on Nov 28, 2009
Nov 13, 2011 | 2003 Pontiac Grand Am
Jan 17, 2010 | 2003 Land Rover Freelander
Oct 19, 2009 | 2003 Pontiac Grand Am
Oct 18, 2009 | 2002 Pontiac Grand Prix
Sep 09, 2009 | 2003 Jeep Grand Cherokee
Jul 02, 2009 | 1999 Pontiac Grand Am GT
Jun 28, 2009 | 2003 Pontiac Grand Prix
Aug 21, 2008 | 1997 Pontiac Grand Prix
Aug 02, 2008 | 2003 Pontiac Grand Am
91 people viewed this question
Usually answered in minutes!
×