Question about 2007 Jeep Wrangler 3.8

1 Answer

2007 jeep wrangler won't start have power, but won't turn over hear a clicking in fuse box. any suggestions?

Posted by Anonymous on


1 Answer


  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Jeep Master
  • 20,706 Answers

Battery is dead.
check fuses, the clicking is the starter relay that is its job is to click.
but if it rattles that means low battery

what we do is a AAA jumper of battery, jump start battery with a donor car. if it starts now. then.
1: the battery was only discharged , so charge it.
2: or if it repeats the battery is bad. OR
3: if the voltage is not 13.3 to 15v running the alternator is shut down.

easy huh, just 3 checks.

Posted on Aug 07, 2014


5 Related Answers


  • 4 Answers

SOURCE: Jeep wrangler Fuse box

i had the same problem. i drive a 95 so im not sure if it differs from were the fuse box is. look righ above you pedals to your far left. it should be right there. also if you instruments went out it will be a 15 fuse. its a blue fuse. next my panel went out cuz of the wires on my transmission. if yor looking at your jeep at the front. the wires will be on your left. make sure they are not burned or anything. it will be right on the side of your tranny. mind got burned by the exaust so they were shorting. check that is and see if that is what is it. for a temp fix just put some electrical tap around the wires and you should be set for a wile. good luck

Posted on Jun 30, 2008



  • 1 Answer

SOURCE: fuse box

Under the left of the dash board close to the parking brake tucked up under.

Posted on Feb 15, 2009


  • 1 Answer

SOURCE: 95 Jeep Wrangler wont start

Well two things are happening here... the people saying fuel regulator, you guys are not having the same problem. the relay buzzing is the indicator that the computer is bad. The relays that are buzzing get engergized by the computer. Notice the Check Engine Light won;t come on until after the buzzing is over. Now the fuel problem is different from that becuse the computer is working fine but the pump can't build enough pressure in the first second (like it is suppose to do) during the priming before you turn the key to start. Sorry for all you with the computer problem ain't cheap...

Posted on May 01, 2009


  • 1 Answer

SOURCE: 95 jeep yj 4 cyl. hard to start when cold. wont

Mine did the same thing. Replaced the computer and works like brand new. Hope this helps.

Posted on Jan 29, 2010


frank thomas wilson

  • 10319 Answers

SOURCE: My son purchased a 92

down load a free owners manual which should have the drawing of the fuse box with the noted circuits involved

Posted on Aug 22, 2010

Add Your Answer


Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Why will my jeep not start

Likely that the "clicking sound" behind the dashboard is the IGNITION RELAY. Start by replacing the ignition relay (inexpensive and easy to replace).

Sep 06, 2014 | 2005 Jeep Wrangler

1 Answer

Why will my jeep not start

Could be starter soilinoid

If you need further help, reach me via phone at

Sep 06, 2014 | 2005 Jeep Wrangler

1 Answer

Where is the interior fuse box on a jeep wrangler sahara 2008?

the operators guide shows that, did you lose it?
here ill open my glove box, and turn to page under fuses.
page 413
the car starting in 2007 has a totally integrated power module.
TIPM under the hood.

the lost book is here, for free, at all jeep dealers.

get it and put it back in car. and not get stranded.

Mar 19, 2014 | Cars & Trucks

1 Answer

06 jeep wrangler will not turn over

Your battery is drained. It has enough juice to activate the starter relay but not enough to turn the starter. murf427

Oct 25, 2012 | 2006 Jeep Wrangler

1 Answer

Have a 2001 Jeep Wrangler. Radio won't start

Fix your car right away by clicking the link I attached
2001 Jeep Wrangler

Dec 04, 2017 | 2001 Jeep Wrangler

1 Answer

95 jeep wrangler 4.0,won,t start,dash lites won,t go on.replaced starter relay.still won,t turn over.

Try checking the battery and battery leads. Sounds as though you have a bad battery. Also check your fuses under the hood and dash.

Jun 03, 2011 | 1995 Jeep Wrangler

1 Answer

Own a 1999 jeep cherokee sport has a problem when attempting to start while turning the key forward i am hearing a clicking noise from the passenger side fuse panel but the starter and engine do not turn...

The clicking noise you hear is likely the starter relay. (should be identified inside the box cover) You need to check that battery is up to full voltage, terminal connections are clean and secure and that there is 12 volts at the main power lead on the starter and power at the small trigger wire connection at the starter when the key is turned to the start position. If you have that, then very likely the starter needs to be replaced. If not you will need to check wiring and neutral safety switch as well as main fuses in the power distribution center (the box where the clicking relay is, near the battery)

Jul 31, 2010 | 1999 Jeep Cherokee

2 Answers

Jeep 2007 Wrangler Unlimited X 4x4 4 Doors

Sounds like a short in the electrical system. Maybe even just a loose ground wire. On the other hand...It could just as easily be a bad ECM (BRAIN)! Warranty still in tact? I hope so. Diagnostic at a certified Jeep shop... Good Luck!

Apr 09, 2010 | 2007 Jeep Wrangler Unlimited Rubicon 2...

4 Answers

2006 Jeep Wrangler won't start

First, make sure you can turn the engine by hand. If you can't then the starter can't turn it either. Have someone else turn the key and look for the source of the click...may be a relay. Go over the starting circuit with a volt meter. Check for power at the starter main terminal and then with the key turned to "start" check for power at the trigger terminal on the starter. Check battery voltage and check relay operation.
You have a neutral safety switch on the transmission if its an automatic and a clutch switch if it's a stick. Check them as well. Make sure battery grounding on fender and block are also clean and secure.

Oct 01, 2009 | 2006 Jeep Wrangler

3 Answers

98 jeepwrangler won't start

This is basic, but first off, try to shift it into neutral, and try to start it. It is easy for the linkage to get out of adjustment, where it thinks the jeep is in gear. If that does not work, make sure you have battery power to the ignition and starter.

Dec 22, 2008 | 1998 Jeep Wrangler

Not finding what you are looking for?
2007 Jeep Wrangler 3.8 Logo

203 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts


Level 3 Expert

85239 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14850 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides