- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Hey Ray I'm looking at a picture of this vehicle but I can't see if the lense has screws in it probably not otherwise you wouldn't be asking anyway I think that you will have to remove the rear door trim panel look for little screw covers and pop those out if none then that panel has clips under it and lightly pry up on them from under the panel to release it and I see that it's in the spoiler so there might be a panel to pop out on that trim panel at the top because that spoiler is not part of the rear door it's a bolt in part attached to it from what I can see in the photos and please go to Tasca parts .Com I just found this body/spoiler for 2015 ford edge there's a diagram of the spoiler with fasteners Tasca is a ford dealer in I think Rhode Island but this diagram should help you good luck stephen
From the GM 2005 Chevrolet Equinox Service Manual:
Remove Spoiler:
1. Open the liftgate
2. Remove the liftgate upper interior trim panel to expose the center bolt
3. Remove the spoiler to liftgate bolts (3)
4. Disconnect the stop lamp harness
5. Disconnect the rear washer hose
6. Lift the spoiler to disengage the locating retainers and remove the spoiler from the liftgate
Remove the high mounted stop lamp assembly:
1. Remove the spoiler to high mounted stop lamp screws
2. Disconnect the electrical connector
3. Disconnect the washer hose
4. Remove the stop lamp from the spoiler
Install the high mounted stop lamp assembly:
1. Position the stop lamp assembly to the spoiler
2. Connect the washer hose
3. Connect the electrical connector
4. Install the spoiler to high mounted stop lamp screws, tighten to 2 N-m (18 lb in)
Install Spoiler:
1. Position spoiler loosely over the liftgate
2. Connect the rear washer hose
3. Connect the stop lamp harness
4.Push down the spoiler to the liftgate to secure the locking tab retainers
5. Install the spoiler to liftgate bolts; tighten to 2 N-m (18 lb in)
6. Install the liftgate upper interior trim panel
7. Close liftgate
That generally means that there was a defect on the application of the finish at the factory. Unfortunately it is not covered by the warranty after this long.
Plastic buttons(they break) hold this on mostly, Top and bottom. At the fender wells you will find screws/bolts you have to remove. Nothing is hidden. Follow the perimeter of the bumper and you find the buttons and screws. To easy.
This is the Spoiler Dude. The spoiler light is attached with screws to the spoiler. You must remove the screws and then the spoiler light will come away from the spoiler. Clip the two wires ( Black & Red ). Attached the new spoiler light ( I can get that for you) with a sleeve. Test the new light with the brake pedal depressed. Screw in the new light and that is it. If you have any questions. Call Spoiler Dude Paul 719-661-8600 [email protected]
yes they are interchangible except the front spoiler is different, but everything else is the same. (the front lower spoiler on the 93 has built in fog lamps)
Pretty easy repair and I could only hope his car is the same color....
×