Question about 2001 Acura MDX

1 Answer

How to change rear main engine seal on acura mdx 2001

How do i change the rear main engine seal on a 2001 acura mdx

Posted by Anonymous on

Ad

1 Answer

Scott Campbell

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Acura Master
  • 713 Answers

Http://www.mdxers.org/forums/73-2001-2006-acura-mdx/47786-mdx-transmission-rear-main-seal-diy-tutorial.html

Posted on Jul 31, 2014

Ad

5 Related Answers

EnginEar

EnginEar

  • 57 Answers

SOURCE: changing cabin airfilter for a 2001 acura mdx

It is. I believe on your MDX you have to remove the glovebox 10mm screws. Then there is a drawer in the plastic HVAC housing that unclips on both sides and slides out. If it hasn't been changed before, on most Honda and Acura SUVs you have to carefully cut the plastic that covers the support to remove the metal bar to get to the drawer. You need to keep the plastic because it screw into it's old position after the job is complete.

Posted on Mar 12, 2009

Ad
co7196

Ned C Cook

  • 3433 Answers

SOURCE: 2006 Acura MDX bluetooth stopped

Bluetooths have batteries, Rechargeable. If it won't hold a charge replace the batt.

Posted on Oct 16, 2009

Anonymous

  • 1 Answer

SOURCE: 2001 Acura MDX Stalling.

you may want to check the ground wire for the engine; if the car just shut down it's possibly an electrical. if the ends are corroded replace.

Posted on Nov 02, 2009

Anonymous

  • 3 Answers

SOURCE: Need to reset the code my Acura MDX navigation

check the side of the glove box. my TL has it on the outside side panel as you look from the driver side. my honda prelude had the code there as well. hope this helps

Posted on Apr 30, 2010

DotRat

Michael Donovan

  • 146 Answers

SOURCE: 2006 acura mdx. battery completely dead now I

You need to get the serial number off the sticker attached to the radio. It will require pulling apart your dash. Call an Acura dealership with that serial number and they should be able to provide you the code. Or you can take it directly to the dealer but you will be charged labor.

Posted on Aug 12, 2010

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Diagram rear main seal


Don't need a diagram, you have to pull the transmission to replace the seal. It is the seal in the engine block that goes around the crankshaft output to the transmission.

Jul 31, 2014 | 2001 Acura MDX

1 Answer

I NEED A FREE SCHEMATIC FOR 2001 ACURA MDX STEREO MODEL 39101-S3V-A131-M1


Hi there:
I suggest to check this on 2001 Acura MDX Car Stereo Radio Wiring Diagram...

Radio Constant 12V+ Wire: White or White/Blue
Radio Ignition Switched 12V+ Wire: White/Red
Radio Ground Wire: Black
Radio Illumination Dimmer Wire: Red/Black
Radio Antenna Trigger Wire: Yellow/White
Radio Amplifier Trigger Wire: N/A
Front Speakers Size: N/A
Front Speakers Location: N/A
Left Front Speaker Wire (+): Blue/Green
Left Front Speaker Wire (-): Gray/Black
Right Front Speaker Wire (+): Red/Green
Right Front Speaker Wire (-): Brown/Black
Rear Speakers Size: N/A
Rear Speakers Location: N/A
Left Rear Speaker Wire (+): Blue/Yellow
Left Rear Speaker Wire (-): Gray/White
Right Rear Speaker Wire (+): Red/Yellow
Right Rear Speaker Wire (-): Brown/White

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Jun 29, 2012 | 2001 Acura MDX

1 Answer

I have a honda acura mdx 2001 the check engine light is on and the vtm-4 light also . what can be the problem?


You will only know the system with the malfunction,
when you retrieve any codes

Then diagnose the issue, using the codes and
a trouble chart

Feb 16, 2011 | 2001 Acura MDX

1 Answer

Need to replace a front heat blower resistor on 2002 mdx, where is located???


moz-screenshot.pngHere's an excerpt from the 2002 Acura MDX 4WD 6cyl Repair guide for replacing what the reference manual calls the "control assembly" - its located under the console rear trim and may (or may not)
contain the blower resistor - my manual doesn't say - but this is the closest thing I could find for you. Every other blower resistor I've had to find was located close to the heater controls - and this
car seems to be no exception -- its heater controls are located in the console between the seats, rather than in the dash (as in Acura 2003-06 MDX models).

You may want to call your friendly Acura dealership ad speak to the parts department, to make sure where the blower resistor is located - or a visit to a dealership parts counter often (or
Advance Auto Parts is helpful too) ofen clarifies questions I have from Haynes manuals (the cheapest car repair guides).

All this assumes that you've correctly diagnosed your blower control problem -- as in "replace the blower resistor when the blower works only on the MAX/Highest setting."

-- begin excerpt from 2001-2 Acura 4wd 6cyl MDX Repair manual --
Control Assembly Removal & Installation

2001-02 Models
  1. Remove the console rear trim. Refer to the accompanying illustration.

    0996b43f80205cf3.jpg enlarge_icon.gifenlarge_tooltip.gif

    Fig. Exploded view of the console rear trim

  2. Remove the self-tapping screws and the rear heater-A/C control unit (A) from the console rear trim (B).

To install:
  1. Install the control unit in the reverse order of removal. After installation, operate the control unit controls to see whether it works properly.
  2. Run the self-diagnosis function to confirm that there are no problems in the system.

    0996b43f80205cf2.jpg enlarge_icon.gifenlarge_tooltip.gif

    Fig. Remove the self-tapping screws and the rear heater-A/C control unit (A) from the console rear trim (B)



  3. --- end excerpt from 2001-2 Acura 4WD MDX 6cyl Repair Manual ---

Jan 02, 2011 | 2002 Acura MDX

1 Answer

Changing cabin airfilter for a 2001 acura mdx


It is. I believe on your MDX you have to remove the glovebox 10mm screws. Then there is a drawer in the plastic HVAC housing that unclips on both sides and slides out. If it hasn't been changed before, on most Honda and Acura SUVs you have to carefully cut the plastic that covers the support to remove the metal bar to get to the drawer. You need to keep the plastic because it screw into it's old position after the job is complete.

Mar 12, 2009 | 2001 Acura MDX

1 Answer

2001 Acura MDX Stalling.


you may want to check the ground wire for the engine; if the car just shut down it's possibly an electrical. if the ends are corroded replace.

Jan 19, 2009 | 2001 Acura MDX

Not finding what you are looking for?
2001 Acura MDX Logo

Related Topics:

949 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acura Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...