Question about Land Rover Discovery
Where is the chassis number located
Posted by Anonymous on
if it is a mems unit , it will need to be programed to the key fob and alarm . (there is no way round it).
Posted on Sep 03, 2009
The Vehicle Identification Number (VIN) plate is stamped on a plate attached to the bonnet locking platform. The VIN is also stamped in the following locations:
1) On a plate behind the LH lower corner of the windscreen.
2) On the chassis RH longitudinal behind the rear wheel.
Posted on Feb 22, 2010
Suggests either Wheel Bearing, ABS Sensor Fault, or Shuttle valve. Best to get it to a dealer and on the computer for them to diagnose what exactly is wrong.
Posted on Feb 24, 2010
As a Land Rover Tech I can tell you that it is true that there is no filter on the series2 there is a small screen at the bottom of the pump pickup that acts as a filter,If you feel this is clogged you can remove the pump by pulling up the rear cargo area carpet as recommended above then just use break clean to clean the screen.Make sure you replace the pump gasket as a faulty gasket will cause a check engine light and a little trick I use is to put a small amount of vaseline on the gasket to ease installation.Also a quick note on series 1 filters is that the lines usually cease up causing the connections to break or damage when removing.I highly recommend getting the repair kit available at the dealer or rovers north before attempting to replace the filter .
BUT IN REGULAR 2004 lan-drover discovery there is fuel filter located.
Removing the fuel filter
The fuel filter is located on bulk head, to left hand side of the engine.
1: Start by cleaning the area around the filter head.2: Place a container beneath the fuel filter to catch any spillage.3: Loosen the bleed screw using a 10mm spanner4: Unscrew the drain tap on the bottom of the filter until the fuel starts coming out into your the container.5: Once all the fuel is drained from the filter, unscrew the whole filter assembly.
Fitting the new fuel filter 6: Clean the seal & seating on the new filter.7: Put a small amount of fuel around the rubber seal to lubricate it.8: Screw the new filter onto the filter head and tighten by hand.10: Tighten the bleed screw.11: You can now crank the engine until fuel is drawn through the system and the engine starts.Job done!
This will help. Thanks please keep updated.please do rate the solution positively .thank you for using fixya
Posted on Mar 18, 2010
Tips for a great answer:
Dec 17, 2015 | Land Rover Cars & Trucks
Sep 13, 2012 | Cars & Trucks
Dec 06, 2010 | 1996 Land Rover Range Rover
Dec 02, 2010 | 2004 Land Rover Discovery
Sep 14, 2010 | 2003 Land Rover Discovery
Apr 03, 2010 | 1999 Land Rover Discovery
Jan 24, 2010 | 2004 Land Rover Discovery
Jan 04, 2010 | 2000 Land Rover Discovery
May 21, 2009 | 1994 Land Rover Discovery
Dec 09, 2008 | 1998 Land Rover Discovery
Sep 12, 2019 | Land Rover Cars & Trucks
Jun 30, 2019 | Land Rover Cars & Trucks
14 people viewed this question
Usually answered in minutes!