I applied the emergency parking brake, the pedal sreleased bu the rear brake did not.
Hello,
if your e-brake is stuck then you could look at the unit on the side and there should be a small lever that you can pull to release the brakes if the cable is not working, the cables themselves could be frozen? or something mechanical inside the drums or calipers in the rear that could be stuck and not moving. there is a possibility that the master cylinder is at fault, but rare. you can open the rear wheel bleed valves and see if the vehicle can move? if so, then check the rubber lines to the wheels? to be bad
SOURCE: How do I reinstall the parking brakes on my 2001 GMC Jimmy.
hi from the uk not too conversant with your model ? BUT here in uk the same type of rear calipers for hydraulic disc brakes and a seperate set of brake shoes operate the park brake/s which is internal of the rotor ?? thebrake shoes will have an adjuster manually adjustment when rotor/drum is in place ? so if you look at the area between the top of shoes you may see a threaded rod with a serrated round wheel which when turned on thread will move shoes out one way and in the other ? so to fit rotor you must rotate this wheel so shoes close up enableing to fit rotor/drum over shoes easily ? then secure rotor with screws?? if fitted then you adjust ppark brake shoes by turning with a flat screwdriver via a hole which is/should? be in rotor and will turn in line with this adjuster? tighten brake on then turn back notch by notch till rotor turns free or just? do this b4 you fit the disc pads then repeat on other brake assy on other side? re assemble discpads and pump brakes till hard this then leaves the park brake cable to adjust if req'd if so pull p/brake it should come up approx 4 or 5 clicks to fully lock of brake this allows for what is known as reserve travel left on cable to apply as brake shoes wear ok? hope this helps?
SOURCE: Emergency Brake Adjustment
Ahh they are a real pain in the **** you need to remove the rear wheels calipers caliper anchors then the rotors and then you can adujust the park brake shoes up just untill you feel a bit of drag on the rotor then back them off a bit. Other wise you need to buy the tools to check the adjustment bottom line they are a pain
SOURCE: Parking Brake on, Under dash release cable broken
Can you get to any part of the cable? If so, use a pair of pliers to release it until you can replace the cable.
SOURCE: Park Brake Adjustment
Park Brake Adjustment (Disc Brake)
Tools Required
j 21177-A Drum-to-Brake Shoe Clearance Gage
Park Brake Shoe Adjustment
Caution: Refer to Brake Dust Caution.
Important: The park brake shoes must be adjusted before the park brake cable tension is adjusted.Set the J 21177-A so it contacts the inside diameter of the rotor
Park Brake Cable Tension Adjustment
Important: Before you adjust the park brake cable tension, verify that the park brake shoes are adjusted to provide a clearance of 0.6604 mm (0.026 in) and the rear disc brake rotors are installed.
265 views
Usually answered in minutes!
×