Question about 1993 Ford Probe

1 Answer

Where is the headlight control module located on a 93 probe?

Posted by Anonymous on


1 Answer

Jay Drogsvold

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.


    An expert who has answered 20 or more questions within one hour.

  • Expert
  • 91 Answers

1 Related Answer


  • 234 Answers

SOURCE: location for the head light control module

The LCM or lighting control module is located under the dash to the right of the steering wheel, first you need to remove the hush panel under the knee brace, then there are 2 screws the hold it to a bracket. Unplug the 4 connectors towards the back and then slide it out and replace.

Posted on Oct 22, 2009


Add Your Answer


Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 06 grand prix the bright lights work but the dim wont come on at all what could this be

Hi, the problem can be the relay or the body control module. The thing to do is pull the low beam relay out of the relay box under the hood and swap it wil the high beam relay. If the low beams start working instead of the low beams, buy another relay for the high beams. If there is no change, pull the relay out again and interrogate the relay socket with a 12 volt test light or voltmeter. Connect your test light clip to chassis ground and probe the relay socket. There should be 2 hot terminals in the socket. If not, there is a problem with the fuse box. If you get these 2 hot terminals, move your test light clip to battery positive and probe the other 2 terminals in the socket. With the headlight switch off, there should be one terminal that lights the test light dimly. If not, there is a problem with the wire from the relay to the headlights. If this is OK, next turn the headlights on (low beam setting) and probe the socket again. There should now be 2 terminals that light the test light. If not, there is a problem with the wiring from the body control module, the module itself, or the beam control switch. If you get to this point, you will need to check the signals AT the BCM to determine if the BCM is to blame of the switch. Please get back to me for these additional steps, if you get stuck here.



Aug 03, 2011 | 2006 Pontiac Grand Prix

1 Answer

Cant to get the headlights to come on

Headlights usually work off relays or a lighting control module. Check owner manual for location of relay and call dealer parts dept and ask what controls headlights. Module or ???

Mar 02, 2011 | 1998 Cadillac DeVille

2 Answers

Were is the esc module on a 93 s10 blazer 4.3 vortec located

Welcome to


Thank you for using

Regards, Lee Davidian

Nov 22, 2010 | Chevrolet S 10 Cars & Trucks

2 Answers

Where is the fuse for power windows?

I know on a 83 its located by the glove compartment ,, try looking there

Aug 02, 2010 | 1990 Chrysler New Yorker

2 Answers

How to connect wiring for a trailer on a 93 dodge caravan?

I suggest check this diagram...


And visit this LINK for other details and parts location.

Good luck (remember rated this).

Jul 31, 2010 | 1993 Dodge Caravan

1 Answer

Park/Tail lights not working. Brake/signals are

Before going ahead and spending money on a new module, test it first. The module is located under the steering column. You'll find a Brown wire on one of the connectors (i just looked at a wire diagram). Do no disconnect anything. Back probe the brown wire, which is the power feed to your park lights. With the lights off, there should be 0 volts on you voltmeter. Turn the park lamps on, There should be 12V. If there is not 12V, disconnect the connector and try to check voltage at the pin that feeds to the brown wire, if still not 12V, replace the module. If you do get 12V, then module is ok, find where the 12v is being dropped before making it to the lamps.

Aug 09, 2009 | 1999 Lincoln Town Car

2 Answers

93 ford probe no spark,gets gas,checked compression replaced cap

you should check power at each one to verify that they have power, which engine do you have 4 or 6 cyl? the 4cyl the coil is seperate from the distributor and the module is located on the side of the distributor, the 6cyl it is all inside the distributor, but to replace parts without verifing power is not cost effective. The most common ignition failure is the ignition module, but you still need to verify that it receives power.

May 18, 2009 | 1993 Ford Probe

1 Answer


The cruise control is control on the 93-99 VW jettas and golfs by a computer module behind the headlight switch. Its common for these to fail. If you pull out your headlight switch you will see two square boxes, a black box, for the alarm, and a silver box for the cruise control replcae it by removing the cover under the steering wheel and unplugging the silver cruise control computer

Feb 25, 2009 | 1997 Volkswagen Jetta

1 Answer


rate a sfixya if this helps.

96 probe 2.0L. don't have 93, but simliar


Feb 24, 2009 | 1993 Ford Probe

2 Answers

Headlights stuck on, cars off, switch is off?????

This is a problem with the DRLM Daytime Running Lamp Module. It is a small black box (2"x2")located in the engine compartment beside the washer fluid jug on a '93 Cherokee. Diconnect and you should be ok. Save yourself the cost of buying a new Headlight Switch like I did.

Aug 19, 2008 | 1995 Jeep Cherokee

Not finding what you are looking for?
1993 Ford Probe Logo

Related Topics:

90 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides