What weight travel trailer will a 1998 dodge avenger pull?

SOURCE: 1998 dodge avenger turn siganl relay

replace flasher unit (located behind the radio)

SOURCE: 09 dodge journey 4cl. enging how much weight could it pull?

the towing weight limit should be listed in the owners manual

SOURCE: 1998 dodge avenger tranmission control solenoid

Below the link for Chrysler/Dodge auto-transmission manual
http://www.scribd.com/doc/7095618/545rfe-Transmission-Manual

Solenoid mounts outside the transmission, so you do not need to remove the transmission to install. It should be located between fuse box and air filter housing on the top of transaxle case and right next to transmission controle module.
I hope his step by step procedure will work for you. It is not hard at all to replace the solenoid. There are three 10mm bolts. You will also need to remove the input speed sensor. One thing to look out for is not bending the gasket when installing the new solenoid:

1. Disconnect battery negative cable.
2. Remove air cleaner assembly.
3. Remove electrical connectors for transmission control module (please refer the manual I send you and autozone.com website).
4. Remove the Transmission Control Module
5. Disconnect and remove the input speed sensor
6. Disconnect the transmission oil cooler lines. Cap off hoses and fittings to prevent foreign matter intrusion.
7. Disconnect the solenoid/pressure switch assembly connector.
8. Remove the three solenoid/pressure switch assembly-to-transaxle case bolts
9. Remove solenoid/pressure switch assembly and gasket

1. Install solenoid/pressure switch assembly to case using a new gasket
2. Install bolts and torque to 13 N·m (110 in. lbs.)
3. Install 8-way connector and torque screw to 4 N·m (35 in. lbs.)
4. Uncap and install transmission oil cooler lines.
5. Install input speed sensor and torque to 27 N·m (20 ft. lbs.)
6. Install Transmission Control Module
7. Install air cleaner assembly.
8. Connect battery negative cable.

SOURCE: Utility trailer wiring to 1998 Dodge Carivan

i have a utility trailer with a six point plug, and the trailer brake wires are white and black. the tail light wiring is brown and red coming out of the tail lights. the coloring of the wiring for the trailer is yellow,green,brown. the running lights, blinkers do not work, the brakes seem to work according to the brake control. can you be of any help. thank you very much.
[email protected]

Greg Bernett

• 2993 Answers
• Posted on Oct 29, 2009

SOURCE: 1998 Dodge Avenger serpentine belt issue

What size of motor, do you have a/c and which belt are you replacing? Not sure about your engine size since you did not list it so please pick the applicable motor:

Sebring Coupe And Avenger (2.5L VIN N Engine)

1. Disconnect the negative battery cable.
   
2. Loosen the tension pulley locknut.
   
3. Rotate the adjusting bolt to decrease the belt tension.
   
4. Remove the drive belt from the engine.
   

1. Position the replacement belt around the pulleys, making sure the belt routing is correct.
   
2. Adjust the belt by rotating the adjusting bolt until the correct tension is reached. Refer to the procedure earlier in this section for belt adjustment.
   
3. Once the desired tension is reached, secure the locknut. Recheck the belt tension.
   
4. After the belt is installed and adjusted properly, tighten the locknut to 17 ft. lbs. (23 Nm).
   
5. Connect the negative battery cable.
   

1. Disconnect the negative battery cable.
   
2. Loosen the tension pulley locknut.
   
3. Rotate the adjusting bolt to decrease the belt tension.
   
4. Remove the drive belt from the engine.
   

1. Position the replacement belt around the pulleys, making sure the belt routing is correct.
   
2. Adjust the belt by rotating the adjusting bolt until the correct tension is reached. Refer to the procedure earlier in this section for belt adjustment.
   
3. Once the desired tension is reached, secure the locknut. Recheck the belt tension.
   
4. After the belt is installed and adjusted properly, tighten the locknut.
   
5. Connect the negative battery cable.