The car has had its 30K service early and the Code 82 plus the maintenance required light. I called Holden and they want $65 to reset it.
1. Hold reset button down while turning ignition on.
2. Keep depressed until display is reset.
SOURCE: Maintenance Required light
The light needs to be reset. Usually after an oil change they will reset it for you. Directions for doing yourself>>> turn off the engine, press and hold the select/reset button in the instrument panel then turn the ignition switch on. Hold the button until the indicator resets (approximately ten seconds). Directions from your Honda manual. Hope this helps!
SOURCE: holden barina 2003
it means its due for service. If u wanna get rid of it without servicing the vehicle then as you start the car simultaneously push the ODOMETER reset button on the dash and it will wipe it. This will however just delay the point your car needs servicing.
SOURCE: engine maintenance required light , stays on
I have a 1995 dodge 2500 with a v10 and it runs rough at idle and the maintenance required light came on. I have tuned it up and replaced o2 sensors also profesionally cleaned the injectors and ran sea foam cleaner thru the intake and all vacum stuff besides egr valve or injectors wut can i do plus do i have to shut off the maintenance required light for the 02 sensors to work right
SOURCE: changing a fuel pump on a 1991 holden barina
The Fuel Pump is Inside the Fuel Tank. You will need to Trop the Fuel tank for this. Not an Easy Job by any Means.
SOURCE: Maintenance Required light on after dead battery
No its easy . here are the steps turn ignition to acc/ first turn hold reset button located next to odometer rest button. Hold this button for 30 seconds. then turn ignition to next turn/click where lights come on on the dash ex brake air bag etc. hold for another 30 seconds. The maintenance light should flash and go out start vehicle and your maintenance is done. Good luck ad thanks for using FIX YA
4,996 views
Usually answered in minutes!
×