Cars & Trucks Logo
A
Anonymous Posted on Jul 12, 2014

91 MAZDA B2200 DIES AND WONT START UNTIL IT SITS AWHILE HAS NO FIRE TO SPARK PLUGS WHEN THIS HAPPENS

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

Mayor:

An expert whose answer got voted for 2 times.

Problem Solver:

An expert who has answered 5 questions.

  • Contributor 5 Answers
  • Posted on Oct 25, 2014
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

Mayor:

An expert whose answer got voted for 2 times.

Problem Solver:

An expert who has answered 5 questions.

Joined: Dec 31, 2008
Answers
5
Questions
0
Helped
5555
Points
9

I'd say the coil is shot. However when ot does happen make sure you still have 12volts going to the coil. This will help eliminate wiring issues.

5 Related Answers

emissionwiz

Marvin

  • 85242 Answers
  • Posted on Mar 29, 2009

SOURCE: My mazda is misfiring with the engine shaking. I

U didn't say what engine so here are both firing order's this is the 2.3L
32da239.gif

Ad

Anonymous

  • 8 Answers
  • Posted on Apr 19, 2009

SOURCE: cannot start 1993 mazda miata

you may want to check your timing

Anonymous

  • 111 Answers
  • Posted on May 23, 2009

SOURCE: Mazda 323 wont start until cold

If this vehicle has a distributor, try replacing the pickup coil. This should be located under your distributor cap and is responsible for spark. When your engine compartment gets warm from normal conditions, this plastic piece of **** shrinks and the metal tab attached to it doesn't make a good enough connection to conduct the electric spark to your plugs. Hope this helps!

Anonymous

  • 215 Answers
  • Posted on Jun 04, 2009

SOURCE: price on a 1991 B2200 Mazda Pickup truck carburetor

Depends if you want new or used, Location, and a few other variables

kirtec auto

  • 1348 Answers
  • Posted on Aug 19, 2009

SOURCE: 1999 mazda prodege 1.6 wont start

no spark. maybe a broken timing belt, bad coil,crank sensor,ecm,ignition module,etc.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer
0helpful
1answer

'88 Mazda 323 cranks, but won't start.

I wouldn't flood one cylinder and expect it to start. Try using a small amount of starting fluid in the air filter to confirm your plug wires are installed and working correctly.
0helpful
1answer

I have a 1992 gmc sonoma and it starts fine when its cold and runs good but when it warms up it dies and wont stay running and sometimes wont start till it sits for 15 20 min

sounds like a bad ignition module check for spark when it dies if you do not have spark at plugs check between coil and coil wire if still no spark most likely module it is under rear of distributer cap resembles a black wafer board with two electrical plugs
0helpful
1answer

91 primera sr18 Di,have fixed vacume leak's in inletmainfold,replaced the airflow meter,have got it running excellently but after it has been running for awhile,it randomly dies and wont start again f

I had a similar problem. Nissan sr18di engine. car would run fine and randomly engine would cut off and only start after 20 minutes. Changed distributer
fine since
2helpful
1answer

New fuel not getting to spark plugs from fuel injectors.

after you replaced the battery did you reset the immobilser,and if the car has been standing for awhile you may need to reset anyway..if it turns over tries to fire up then dies.....
1helpful
1answer

What is the gap setting on the spark plugs. please, 1991 mazda b2200

1992 MAZDA B2200 L4 - 2.2L - FI - - GAS

Part Number RN12YC - .035"

Hope this help (remember rated this) Good luck.
0helpful
1answer

When im driving my truck,it starts to sputter and

I would try spark plugs and wires. If it was a fuel line you would see the leak or atleast smell it very strongly. If the problem still exists after new plugs and wires try the distributor cap.
0helpful
1answer

Wont Start

Have another look at your plug wires, and make sure that you have them in the right order. As you probably know, if the firing order is wrong, you can have problems. That is somewhere for you to start, anyway.
Not finding what you are looking for?

638 views

Ask a Question

Usually answered in minutes!

Top Mazda Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...