1997 GMC Yukon Logo

Related Topics:

A
Anonymous Posted on Jul 11, 2014

Where is the fuel pump fuse located on a 97 gmc yukon

My gmc yukon would not start and the dealer replaced the fuel pump fuse the same thing happen again....where is the fuel pump fuse located

5 Related Answers

Anonymous

  • 161 Answers
  • Posted on Jun 18, 2009

SOURCE: 1997 Gmc yukon fuel relay switch continues to burn out

I would have to check the fuel pump with a scope to look at the pattern and check the amps it is drawing . the grounds need to be checked and the pcm checked and reflashed. on the fuel system that would affect the fuel pump and relay to where it would burn it out is grounds , pcm , fuel pump , fuel pump relay. so you should convince them to replace the fuel pump and fuel pump relay under warranty and replace the pcm . and get a diagram and check all grounds. If the pcm is damaged and the current has been affected and instead of say a 5 volt or 2 volt signal it now has a 13.5 volt signal or if a ground is out then the temp of the relay will keep rising non energized a relay is about 99 energized it is around 140 you can check to see how hot that relay is getting. and if i remember correctly you want the pcm drivers checked.

Ad

Anonymous

  • 10 Answers
  • Posted on Jul 28, 2009

SOURCE: fuel pump fuse located on 1997 gmc sierra

The fuse is actually a Relay Switch and its located in the Fuse Relay Center on the driverside of the engine compartment. The Black Box is labled Fuse Relay Center, the diagram on the cap displays which Relay is the Fuel Pump relay...the Relay switch is usually $8-$15 depending on where you shop

Molson02536

Harvey N Tawatao

  • 3854 Answers
  • Posted on Sep 04, 2009

SOURCE: 2003 GMC Yukon - fuel pump

Check your ECM fuse. There should be 2 fuses for your ECM. It's the ECM that controls the function of the fuel pump. Good luck friend and it's also common for the wire harness from the frame to the fuel pump to go bad due to corrosion from the bad weather we get in the winter and rainy spring and fall. 

Anonymous

  • 11 Answers
  • Posted on Dec 09, 2009

SOURCE: 1997 GMC Yukon won't start.

WHEN YOU REPLACED THE FP DID YOU OR THE DEALIERSHIP REPLACE THE FUEL FILTER MAYBE YOUR PROBLEM ....

Testimonial: "They did replace the filter but thank you very much for the tip."

Anonymous

  • 237 Answers
  • Posted on Dec 15, 2009

SOURCE: 1998 gmc 2500 sle 5.7 wont stay running

this is in fact the right answer check the oil guage in the truck it should read about 375.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

Need to locate fuel pump fuse for a 2002 yukon replaced relay and it starts but eventually dies out

If fuse was bad it would not start at all, definitely not the fuse, running for a while usually means that something gets hot, and thermal switch kills it.
0helpful
2answers

Trying to find fuel pump fuse for 2002 yukon it starts up but dies out i replaced the relay now i need to know were the fuse is located

Before replacing anything you people need to go to school and learn how to test . starts up but dies out . Is security light lit on the instrument cluster ? anti-theft system . will disable injectors if there is a problem .
0helpful
1answer

2001 gmc Yukon xl stalling

Could be your fuel pump relay.Here's a link to what it looks like.
  • The Fuel Pump relay on this vehicle is located in the under the hood fuse block. It is labeled "F

0helpful
1answer

Trying to locate the fuse box for the fuel pump under the hood of a 1996 gmc yukon

fuse relay box should have diagram or legend on the cover that will give you fuel pump fuse and relay locations.or look in the owners manual.
2helpful
3answers

Will not start wnen less than one fourth tank of fuel. 2003 Yukon

Do you park on a hill? Try pumping the gas pedal a few times before you start it. Check that there is no fuel being dropped, check under the car for rusted fuel lines and any drips.

Hope this helps and vote for me please Thanks.
1helpful
2answers

97' GMC Yukon is not getting fuel

Oil Pressure sensor (behind Distributor), could also be the plug to the fuel pump itself. (pump is in the tank) they tend to get hot and short the fuel pump out even when new. Could also be the fuel solenoid. (cube in fuse box under the hood on left side)
4helpful
2answers

Have a 1995 gmc yukon 2dr i have change the fuel assmble the fuel pump the feed line and return line i have no power to the fuel pump anf help your be gratful ......

On a NO Power to FUEL Pump Problem One Must ALWAYS Start from the Begining of the THAT CURCIUT, This Being the Fuse , Then The FUEL PUMP Relay , And Then WIRING , and LAST Is The PUMP Itself. Here is Info on the RELAY. rejakwilsoin @ aol.com < is my Email Address if you want More info Feel free to Contact me.

The Fuel Pump Relay is located in Underhood Fuse Relay Center. The Underhood Fuse Relay Center is located on the LH rear of engine compartment, on fender.


REMOVE OR DISCONNECT
  1. Protective cover.
  2. Retainer, if installed.
  3. Electrical connector.
  4. Relay by depressing bracket clip at rear of relay, or removing bolts from retaining bracket.
INSTALL OR CONNECT
  1. Relay.
  2. Electrical connector.
  3. Retainer.
  4. Protective cover.
0helpful
2answers

2003 GMC Yukon - fuel pump

Have you verified voltage at the fuse and fuel pump relay. There is one fuse in the underhood fuse box.
Let me know.
Regards,
1helpful
2answers

There isn't any fuel getting to my truck and it won't start

No fuel pressure indicates one of three problems. Fuse in fuse box, relay in relay box under the hood or fuel pump located in fuel tank.
Not finding what you are looking for?

300 views

Ask a Question

Usually answered in minutes!

Top GMC Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

john h

Level 3 Expert

29494 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...