Question about 1983 Dodge Pickup

Open Question

83 dodge full size pickup with 318 not getting spark from coil have change resistor block no go

What can be causing it not to fire

Posted by Anonymous on

Ad

4 Related Answers

Richard Delahant

  • 1201 Answers

SOURCE: 1992 dodge 318 engine turns over, but no start. No

Some dodges have an oblong shaped white ceramic block, either mounted on the firewall or on inner fender well, with wire connections, one on each end, if there is one, replace it.

Posted on Mar 16, 2009

Ad

Christopher Keene

  • 201 Answers

SOURCE: 1992 dodge 318 engine turns over, but no start. No

if truck has a ceramic ballist resistor near and connected to coil this could be problem or the crk posistion sensor could be too, i would change ballast first if you have on your truck appx cost $10

Posted on May 09, 2009

Ad

Anonymous

  • 51 Answers

SOURCE: I have a 1985 dodge ram with a 1988 318 engine no

have the module tested. check for voltage at the dis and coil

Posted on Oct 24, 2009

csmock132

Clint Smock

  • 4669 Answers

SOURCE: 318 dodge 1500 no spark new coil still no spark

Sounds like a bad crank sensor.

Posted on Jul 25, 2010

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Will broke motor mounts cause a miss fire on 96 5.7 vortex truck


Yes a broken motor mount can cause any vehicle to miss fire.

Feb 23, 2017 | Cars & Trucks

1 Answer

It mayI have no fire going to the coil or from the coil to the plugs


Have you checked the wiring, the spark @ plug, Power to the coil???

Engine Won't Start No Spark - Auto Diagnosis Repair Help

aa1car.com/library/no_spark.htm
If your engine cranks normally but will not start because it has no spark, or it ... If an engine has a coil-on-plug ignition system with no plug wires, remove one of ...

No-start, No-Spark diagnosing simulated - YouTube

? 5:13
https://www.youtube.com/watch?v=XSWN1M8Hoqo
May 19, 2010 - Uploaded by FrankHurtAuto
Simulation of no start with no spark diagnosing, ... Ignition coiland module test with test light (ScannerDanner Premium lecture) - Duration: ...

getting fire from coil but not to plugs - CarGurus

www.cargurus.com > Questions > Dodge > Ram 1500

CarGurusJun 12, 2013 - 2000 dodge ram 1500 4x4 not getting fire changed distributor cap, coil, pickup ignition, rotor, plugs, plug wires 2 answers. ... 1994 dodge 5.9 just shut off and wont start back up there is no spark or fire from coil or plugs. ... 94 dodge van 318 eng will not start new plugs new crank ...

Ignition Coil Troubleshooting: (No) Fire in the Hole

www.secondchancegarage.com/public/coil-troubleshooting.cfm

Jan 27, 2016 | Cars & Trucks

1 Answer

What caused this car to catch on fire?


Sorry no idea without more information ,what make model year might help a bit .But most vehicle fires are caused by deterioration of fuel pipes ,they leak and then this catches fire so its down to bad maintenance

Dec 07, 2015 | Cars & Trucks

2 Answers

I have a 1990 Dodge Ram 150 with the 318 engine that the coil isnt sending fire to the dist...But the coil is good. Could someone help?


Could be a bad coil, or a bad pickup coil inside the distributor, or worst case a bad pcm.

You said the coil is good, but didn't mention if you had tested the coil's primary and secondary circuits with an ohmmeter to see if they are within specs? And the pickup coil is like a crank position sensor: it tells the pcm crankshaft position and rpm so the computer can determine spark timing.

Dec 19, 2014 | Dodge Cars & Trucks

2 Answers

4 brl rochester carb


Backfiring is caused by either the firing order being incorrect or the engine timing is incorrect. generally backfiring through the carburetor is caused by incorrect firing order. confirm the distributor is inserted properly and double check firing order beginning with cylinder number 1.

Mar 22, 2014 | 1984 Buick Regal

1 Answer

81 full size blazer back firing. i changed spark plug wiring. still back firing any solutions.


check thie rotor and inside the cap for any signs of arc's or burn areas, any debris built up on the contacts inside the cap will cause the motor to fire wrong and late , which would cause backfiring

Jul 23, 2011 | Chevrolet Blazer Cars & Trucks

1 Answer

Misfiring on the 1 and 3 cyclinder. need firing order to figure out what is causing it. Do you know firing order or what could cause misfire?


Misfire could be caused from bad plugs, plug wires, coils, injectors or fuel pressure. How many miles on the plugs and wires? Were the plugs gapped correctly? Time for a tune-up? You can get the parts you need as well as firing order and diagragm to show which cylinder is 1, 2, 3, 4,5 and 6 at Auto Zone.

Mar 15, 2010 | 2001 Ford Windstar

3 Answers

Ever heard of a transmission overheating enough to cause fire?


It is very unlikely that the transmission would over heat enough to cause a fire anywhere in the passenger compartment. If in fact there was a fire in the passenger quarter panel area there are two things that would be the cause. Either wiring behind the kick panel became shorted and caused the fire or the exhaust became extremely overheated and caused the fire.

Nov 17, 2009 | 2007 Dodge Ram 3500 Quad Cab Laramie

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

118 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14852 Answers

Mike

Level 3 Expert

4372 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...