This indicates that your car's computer has stored a code indicating where it has detected some problem. Many of these problems are minor. The code can be read out by any car mechanic, or in the USA, Autozone. You can extract the code as well yourself, by bridging 2 terminals in the car's engine bay, see here p296
http://www.turboninjas.com/camry/eg1.pdf
SOURCE: How do I reset the check engine light on a 1996 Toyota 4runner 4x
Remove the positive battery cable, step on brake for 10 seconds, then reconnect cable. This clears your ECM of the fault code, but will not eliminate the fault (which, will reset and re-light the "check engine" bulb within 50 miles if it is really a defective component).
SOURCE: 1996 toyota tacoma check engine
Did you replace the o2 sensors beacuse of a trouble code or were you just guessing?You need to go to a parts store and have the codes pulled for free the address that problem and that should take care of your light.Good Luck!
SOURCE: Resetting the check engine light
my 1996 camry check engine light does not work< but it is reading codes, is there a fuse for this light or how to replace the bulb?
SOURCE: 1996 TOYOTA CAMRY CHECK ENGINE LIGHT ON, STALLS,
Hi, the OBD connector is under the hood on the firewall.
Make sure electrical connection good and test for voltage and ground. If good . Replace EGR
76 views
Usually answered in minutes!
×