- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Some fixya user told me a website reliable-store it is very good.. I used it to repair my shredder it had some spark issue which wasn't easily fixed. you can go there and try
glow light bulb could be burned out.but glow plugs is control by ECM AND RELAY.do your vechicle start but you dont see glow plug light on to let you know glow plugs are energized heating up.also check glow plug fuse, look in owner manual in glovecompartment it will show all fuses and relays locations.
With most relays, you have 4 wires. One is power to the component the relay controls, one is a ground to the relay magnet, one is power to the magnet, and the fourth goes to the component, in this case the glow plugs. The ground usually comes from the computer. With the key on you should have power to two terminals and you would jumper the hot terminal to the glow plug terminal. Or use a test light or meter to check for power on the glow plug circuit.
I would change fuel filter any way only £6 delivered on ebay then i would start looking at glow plugs and relays first check to make sure glow plugs are getting a live feed bad side glow plugs are located under drivers seat side of engine so not easy to get at unless you remove seat carpet and engine covers
×