How to remove door regulator on saturn L200 - 1994 Saturn Sl

notify shops in your area pricing is different everywhere fixya doesnt do estimates --

Hershel, Check the attached links Saturn alternator replacement,instruction and guides, hopefully this will show you the wire in question. Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
2002 Saturn alternator wires Google Search

Alternator Removal

2001 Saturn L200 Alternator replacement

2001 Saturn L200 LS Series with 2 2L Ecotec Engine Alternator Replacement

Search Results

2002 saturn l200 headlights and dash lights blinking - Saturn ...

www.saturnforum.com/.../saturn-l-series.../2002-saturn-l200-headlights-...
Mar 6, 2013 - My wife told me that on occasion the headlights and the dash lights willblink when she lets off the. ... 2002 saturn l200 headlights and dash lights blinking.... 2000 LW2 dash lights Inop, spotts56, Saturn L Series Sedans & ...

Saturn l-300 wagon has flickering lights - Car Forums at Edmunds.com

forums.edmunds.com > Saturn > Saturn L300
My wagon 2003 l-300 has flickering lights and when the radio is off you can hear the ...My Dad has a 2002 Saturn Lw series wagon. the transmition has been ...

why a green light always keep flashing when running? - SaturnFans ...

www.saturnfans.com > ... > Models > Saturn S-Series > S-Series General

Apr 17, 2007 - 20 posts - ‎14 authors
S-Series General. ... A green light alwyas keep flashing when my saturn 2002 sl2 .... I had a similar issue with the headlights of a 2002 Impala, but it was an .... I never noticed on my SL2, my L200 or on my Ion now if they come ... Flashing Dash Lights
8 posts
Oct 20, 2008
Flickering lights?
9 posts
Nov 21, 2007
L300 2004 - Lights Flickering - Have some help
5 posts
Nov 2, 2005
Flickering Lights
9 posts
Feb 5, 2005
More results from www.saturnfans.com

Engine Swap question - 2.2 - SaturnFans.com Forums

www.saturnfans.com > ... > Models > Saturn L-Series > L-Series Tech

May 18, 2012 - 4 posts - ‎2 authors
Engine Swap question - 2.2 L-Series Tech. ... which engine i can use to swap into my 2000 LS1 Saturn (stick but i don't think this maters). Saturn L200 Ecotec interchangeable parts
9 posts
Sep 1, 2013
2002 Vue 2.2 Engine Removal out top or lower out ...
20 posts
Aug 22, 2011
Question: Transmission swap
12 posts
May 25, 2007
S-Series Swap Guide
20 posts
Nov 10, 2006
More results from www.saturnfans.com

need tips on locating a 2.2L saturn engine... - Hot Rod Forum ...

Search Results

2001 L200 Cranks but won't start - SaturnFans.com Forums

www.saturnfans.com > ... > Models > Saturn L-Series > L-Series Tech

Nov 28, 2010 - 15 posts - ‎5 authors
I have a 2001 Saturn L200 with 69K miles on the twin cam 16 valve 2.2 ... It will crank but will not start unless I put the gas pedal to the floor in ... Saturn L200 Cranks but won't start
7 posts
Mar 12, 2012
2001 Saturn SC2 Cranks but does not start
11 posts
Dec 4, 2011
2001 L200 won't start
11 posts
Dec 19, 2009
Widow in need - L200 will not start - fuel pressure
12 posts
Nov 12, 2009
More results from www.saturnfans.com


2000 Saturn LS1, Starting Defect - YouTube

? 1:37
www.youtube.com/watch?v=CBNU1IMqaRw

Aug 9, 2009 - Uploaded by farmerinchico
The anti theft system in the 2000 Saturn LS1, thinks you're trying to steal the car ... Once the security light is not flashing you canstart the car.

Do all other windows work ? One relay powers all windows . If all others work possible switch , window motor or window regulator ! Test for battery voltage at the switch with a volt meter , then test at the motor ! 2002 Saturn L200 Window Regulator Repair Part 1 If I were a betting man I would bet the regulator is bad !

Saturn Coupes/Sedans/Wagons 1991-1998 Repair Guide
Door Glass and Regulator - REMOVAL & INSTALLATION
(see Figures 1, 2, 3 and 4)

1. Remove the outer door panel assembly. Refer to the sub-procedure under Door Locks, earlier in this section.
2. For rear doors, loosen the bottom fastener of the rear door stationary window assembly, in order to provide clearance, then apply tape to the lower half of the outboard exposed portion of the stationary window channel. The tape must be applied in order to prevent damage to the paint surface.
3. Lower the door glass, then use SA9148B, or an equivalent tool, to remove the glass nuts. Push the glass upward and rotate slightly, then remove the glass from the vehicle.
4. If the regulator is also to be removed, proceed as follows:
   1. Remove the inner door trim panel. Refer to the procedure earlier in this section.
   2. If applicable, unplug the wiring harness from the power regulator.
   3. Except for the rear door, remove the regulator cam bolts.
   4. Drill out the regulator rivets and remove the regulator from the vehicle.

To install:

1. If removed, install the regulator to the door assembly:
   1. Position the regulator to the door and secure using rivets.
   2. Except for the rear door, install the cam bolts.
   3. If applicable, connect the wiring harness to the regulator.
   4. Install the inner door trim panel to the vehicle.
2. Install the door glass into the door and over the regulator studs.
3. Install the glass nuts using tool SA9148B, or equivalent.
4. Check the door glass for proper operation and alignment.
5. If necessary, adjust the glass alignment. For rear doors, fore/aft adjustments are made after loosening the B bolts, while in/out adjustments are made when the A bolts are loosened.
6. Except for the rear doors, glass which is not running parallel to the door header may be adjusted after loosening the inner panel cam attachment bolts and adjusting the cam. If the glass is floating in the opening, lower the glass 3 / 4 downward, loosen the front guide fasteners, push the glass rearward to seat it in the rear channel, then bring the front glass guide back to the front edge of the glass. Apply a light finger pressure on the guide and tighten the fasteners.
7. Once the glass has been properly adjusted and is operating smoothly, install the outer door panel assembly.

Fig. 1: Remove the glass nuts using a suitable tool-front door shown



Fig. 2: Exploded view of the regulator mounting-except rear door



Fig. 3: Exploded view of the rear door regulator mounting



Fig. 4: Adjustments of rear door glass are made after loosening the A or B bolts


I hope help with this (remember rated this help) Good luck.

Just wanted to let everyone know, in order to change the window regulator on a 1996 saturn you do need to remove the exterior door which is connected by about ten lock screws around the inside of the door. you also need to remove the side view mirror and the door handle which has a little plug on the bottom right side that should come out with a pair of needle nose or something, then the handle should slight to the left and off. Pull the hole outer panel up and off and there you go. But you do still need to remove the inner door panel to put new nuts and bolts to hold the new regulator in because the orginals are held in buy rivets so you have to drill those out.
Hope that helps anyone.
-Jensen-

The speaker should be removed from the trunk. You shouldn't have to remove it from the back seat. There is probably just a couple of clips or screws that hold them in

that option is not avialable on that model.