How do I change spark plugs in a 2001 Buick park ave v6 super charge

Ot Tap

• 253 Answers
• Posted on Mar 14, 2009

SOURCE: how do you change the fuel pump?

You will have to drop the fuel tank. It is nn the tank. dran fueal use jack stands to surport auto. I use a floor jack ti lower the tank. Take car to un hook the hoses to the tank and the fuel level wires.

SOURCE: 92 buick park ave security light on car wont start

Someone put the wrong key (resistor value) in the ignition lock, you will have to disconect the battery for 3 min. Make sure you have the right key. Very important! Make sure the climate control is off before disconecting/conecting the battery.

Donnie Matney

• 426 Answers
• Posted on Jun 19, 2009

SOURCE: Cannot change 3 rear spark plugs on 1999 Buick park avenue

there is a special tool for this job but I have cheated on this but you ned to be careful when doing this.The wishbone shaped mount on the front going from motor to front of vehicle, remove and it allows the motor to tilt.

SOURCE: 91 Buick Park Ave won't start

i just came across this problem myself the other day. i have a 91 buick park avenue that sometimes won't start. i checked several things out like cable connections and coil pack etc. etc. come to find out it was the wiring that came off the coil pack and connects to the crank sensor. the wiring that ran over top of the water pump had finally heated up so bad the coating on the wires had melted and when the engine got hot enough the wires would come in contact and send false signals to the computer not letting it start. after the car cools down and the wires contract it would start. so check the wires from the coil pack to the crank sensor to make sure the wires are not melted together.

Duane Wong

• 6826 Answers
• Posted on Oct 29, 2010

SOURCE: i am looking for a spark plug wiring diagram for

Sometimes the coil packs are numbered from the factory --- Firing Order 1-6-5-4-3-2
Ignition Coil Removal & Installation To Remove:
Ignition Coils

1. Before servicing the vehicle, refer to the service precautions in the beginning of this section
2. Disconnect the spark plug wires from the coils
3. Remove the fasteners securing the coil(s)
4. Remove the coil(s) from the ignition control module

1. Install the coil(s) to the ignition module
2. Install the coil fasteners
   • Torque to 40 in-lbs (4.5 Nm)
3. Connect the spark plug wires to coil assemblies

1. Before servicing the vehicle, refer to the service precautions in the beginning of this section
2. Turn the ignition OFF
3. Disconnect the 14-way connector from the ignition module
4. Note the position of the spark plug wires and disconnect from the coils
5. Remove the fasteners securing the coil(s)
6. Remove the coils and the Ignition module from the bracket

1. Install the coils and the ignition module to the bracket
2. Install the fasteners that retain the ignition coils to the ignition module
   • Torque the fasteners to 40 in-lbs (4.5 Nm)
3. Install the nuts and washers that retain the ignition module to the bracket
   • Torque the screws to 70 in-lbs (8 Nm)
4. Connect the spark plug wires to the coils assemblies
5. Connect the 14-way connector to the ignition module
   • Torque the screw to 19 in-lbs (2.1 Nm)