In the tank itself - you need to remove the load space carpet, then remove the screws in the cover plate. Why do you want to know anyway? Turn on the ignition, go to the loadspace and listen for the pump.It is just a likely to be a broken (white) wire to the pump.
SOURCE: default code P1451 Land Rover Discovery II
The code P1451 on a Land Rover is "Leakage Detection Module Motor power stage error Drive cycle A:Signal out of range - above maximum". This is an OBD-II diagnostic system code. As far as I know, a 1995 Land Rover Discovery does not use a OBD-II system. Is it possible that this rover is a later model year
SOURCE: transfer case oil change- 1999 Land Rover Discovery II
No need for a diagram, to drain the oil, there's a drain plug on the bottom of the transfer box, under the handbrake drum. To fill, the fill plug is about in line with the centre of the handbrake drum and to the left. I think both plugs are 1/2" square. Fill to overflow with Texaco Multi-Gear 75W/90R. Takes about 2L or so.
SOURCE: WHERE IS THE FUEL FILTER LOCATED ON LAND ROVER DISCOVERY 2000
LAND ROVER DISCOVERY II DONT HAVE FUEL FILTER, ONLY HAVE PRE FILTER IN THE FUEL PUMP
SOURCE: 2001 land rover discovery II locate fuel filter and fuel pump
If you're standing looking at the rear of the vehicle, it's on the chassis rail on the right hand side rear wheel arch.
SOURCE: 2001 land rover discovery II locate fuel filter and fuel pump
for Land Rover Discovery 1999-2004 no more external Fuel Filter serviceable anymore...it's a built-in part with the fuel pump. so if you want to change the filter then change the whole fuel PUMP.
31 views
Usually answered in minutes!
×