Question about 1990 Daihatsu Rocky

Open Question

My daihatsu 4 trak has an intermittent starting fault, When the key is turned and ignition lights appear , I wait for the 2 clicks that come from underneath the bonnet and it starts,When i turn key to same position and only hear 1 click it does not turn engine over, I assume starter ok and suspect a relay at fault.

Posted by Anonymous on

Ad

5 Related Answers

Anonymous

  • 1 Answer

SOURCE: INTERMITTENT STARTING FAULT DEALER HAS

my 1990 charade had same problem,tried every thing ended up just turn key off and on farly fast.by that i mean just so the dash lights go on and off.dont ingadge starter,then it should start striataway... from bushmacanic'

Posted on Aug 02, 2008

Ad

Anonymous

  • 98 Answers

SOURCE: daihatsu hijet 4wd van 1985 model 3 cyl 4 stroke 993cc valv tmg

If the belt has slipped you might be in trouble, becuase it's an interference engine.

e9f5605.jpg

Posted on Feb 03, 2009

Ad

Anonymous

  • 14 Answers

SOURCE: electrical problem i think, wen i went 2 started it it wouldnt

i would get a friend to tap on startermotor body with a shifter or something and if car starts when being tapped by friend and you turn key,you need to get startermotor looked at or new one..

Posted on Mar 03, 2009

Anonymous

  • 3 Answers

SOURCE: Unable to take key out ignition, when I stoppped the engine from my 1994 Daihatsu Charade

Shifter must be in PARK position when you turn off the engine before you can remove the key.Hope this helps

Posted on Aug 22, 2009

Anonymous

  • 1 Answer

SOURCE: Daihatsu applause intermittent engine problem

engine cranck but connot start

Posted on Nov 03, 2010

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does engine warning light keep coming on?
Most common fault is a sensor, possibly the engine temperature sensor or the lambda sensor. You should read you fault codes (DTCs) in a workshop or Google the procedure for "blink code DTC retrieval" . On Daihatsu you can do a lot of things by connecting two specific contacts in the diagnostic connector above the driver legs, then turn ignition on. Like DTCS, coding keys and remotes etc.

Mar 26, 2016 | 2004 Daihatsu Terios

Tip

How to reset AIRBAG SRS Light on 2003 - 2006 Infiniti G35 Coupe
Hi, on most vehicles, the airbag light should come on for at 6 seconds, and then go off if the system is working properly. If there is a fault or a problem in the system, the light will remain illuminated, or flash continuously. If the airbag light does not work properly, some vehicles have an audible tone that sounds indicating a problem with the airbag light system. When the light is on (or the tone is sounding), the airbag will NOT deploy, even in an accident. <br /> The flashing light on your car is telling there is a problem. <br /> <br /> <b>How to reset AIRBAG SRS Light on 2003 - 2006 Infiniti G35 Coupe </b> <br /> Ignition Key Method: <br /> <ul> <li>Turn IGNITION on (but don't start car).</li> <li>After the AIR BAG warning lamp lights for 7 seconds, turn IGNITION off within 1 second.</li> <li>Wait 4 seconds.</li> <li>Turn IGNITION on (but don't start car).</li> <li>After the AIR BAG warning lamp lights for 7 seconds, turn IGNITION off within 1 second.</li> <li>Wait 4 seconds.</li> <li>Turn IGNITION on (but don't start car).</li> <li>After the AIR BAG warning lamp lights for 7 seconds, turn IGNITION off within 1 second.</li> <li>Wait 4 seconds.</li> <li>Turn IGNITION on (but don't start car).</li> <li>Wait 3 seconds.</li> <li>Turn IGNITION off.</li> <li>Wait 2 seconds.</li> <li>START Car (the light may be blinking slower than before).</li> <li>Wait 3 seconds.</li> <li>Turn IGNITION off.</li> <li>Wait 3 seconds.</li> <li>START Car.</li></ul> <br /> <b>This is a little easier</b> To reset the light simply turn the iginition to the on position, (you dont need to start it). All the lights should stay on for thier diagnostic check. As soon as the airbag light goes off, before it starts flashing, immeditatly turn the car off. Repeat this 3 or 4 times (turning to on then off) and the light should go away

on Dec 07, 2010 | Infiniti G35 Cars & Trucks

1 Answer

Have power but having intermittent staring problems
New battery

Nov 16, 2015 | 2003 Chrysler Sebring

1 Answer

I have 01 freelander td4 with intermittent starting problem has to be jumped most mornings turn key and no clicking noise or anything just dead,if I wait until mid afternoon n start it then its fine so not...
have checked whether you have any fault with the ignition switch socket?

Nov 22, 2013 | Cars & Trucks

1 Answer

Reset passlock code
Is your Impala a 2000, 2001, or 2002? This seems to be a common problem in those model years...much like its predecessor the GM VATS (Vehicle Anti-Theft System). While the VATS had a permanent (albeit unapproved) solution, no suck workaround appears to be available for the Passlock system. Some websites offer a correction "module" that looks to be a hit-or-miss solution. I did find the following procedure on a forum, and it seems to be reliable. Here goes:
If your car has been sitting while you were at work or home or in the store, and you are coming out to leave, follow steps 1-6.

If you just had the SECURITY SYSTEM lock you out of the ignition system, you will have to wait the 10 minutes for it to reset and allow the ignition control module to interact with the system. Once the 10 minutes have passed from the ACTIVE SECURITY STATUS, follow steps 1-6. Do not try to shortcut this as it wont work.

If it is raining, you can close your door, just not all the way. Close it all the way and open the door latch without pushing the door open. This will keep you dry.

+++++STEPS+++++ 1.) OPEN YOUR DRIVERS DOOR AND SIT DOWN. 2.) PLACE KEY IN IGNITION, WAIT FOR CHIME. (3 seconds is what I usually wait) 3.) TURN IGNITION 1 CLICK RIGHT (TO THE ACC POSITION) AND STOP! Do not continue to ON and START yet. WAIT ATLEAST 5 SECONDS 4.) AFTER 5 seconds has passed, TURN KEY TO ON and STOP, DO NOT CONTINUE TO START YET! 5.) WAIT AND WATCH. With your drivers door open, here is what you will see and hear = Your notification will signal DOOR ADJAR, then the BATTERY light, then the SECURITY light, during which you will hear the chime sound as if you just started the car. 6.) AFTER YOU SEE THE SECURITY light switch back to DOOR ADJAR or Battery, and after the CHIME has stopped, you can turn the key to start and voila!

It has worked every time for me and 5 of my friends. This whole process takes about 20-30 seconds, but it sure as hell beats 30 minutes, as GM refuses to compensate my time lost to their vehicle\'s design flaws.

RECAP: 1.) Open driver door, sit down 2.) Insert key in ignition, wait for chime 3.) Once chime starts wait 3 seconds 4.) Turn key to ACC position WAIT atleast 5 seconds 5.) After 5 seconds turn key to the ON postion and wait for the security light to switch back to Battery or DOOR adjar, and the chime to stop (Do not try to START if the chime is still sounding) 6.) Once chime stops and Security light has passed, You may now complete the turn to START and it will start.

Note: This is not a permanent workaround, but it will buy you some time, I can almost guarantee it will work for most if not all people, almost all the time.

Oct 11, 2013 | Chevrolet Impala Cars & Trucks

1 Answer

05 year lt 35 2.5 tdi turning over but not starting intermittent problem
change the glow plug

Apr 29, 2012 | Cars & Trucks

1 Answer

When I see the light appear on the
security feature
turn ignition to on wait 5 - 10 min light will go off than the car will start if you have the 2 original keys it might be time to program a new key

Jan 23, 2010 | 1992 Honda Prelude

2 Answers

How can I get rid of the messages on my board....(ie. regular maintenance due)
1. Press and hold trip odometer reset button 2. Turn ignition key to run position KPII (not the start position)
3. Wait 30 seconds or until service light "!" begins blinking
4. Release Trip Odometer button
5. Turn ignition to off position
If that doesn't work try:
1. Press and hold trip odometer reset button
2. Turn ignition key to run position (not the start position)
3. Wait 30 seconds or until service light "!" begins blinking
4. Turn ignition to off position, the service light continues blinking
5. Release Trip Odometer button

should reset it for you

Jul 03, 2009 | 2003 Volvo S60

2 Answers

1993 Acura - intermittent fuel pump operation (no start)
I thing it is definitely the fuel relay. I had the same problem. The relay is quite big and it is located and bolted under the dash on the driver side, brown in color. You can't miss it.

Aug 06, 2008 | 1993 Acura Integra Hatchback

1 Answer

INTERMITTENT STARTING FAULT DEALER HAS REPLACED KEY AND IMMOBLISER ECU. ONCE STARTED AND TURNED OFF IT WILL RESTART BUT LEFT FOR FIVE MINS IT WILL NOT RESTART THE CAR IS A DAIHATSU TERIOS 2002 WITH A K3-VE...
my 1990 charade had same problem,tried every thing ended up just turn key off and on farly fast.by that i mean just so the dash lights go on and off.dont ingadge starter,then it should start striataway... from bushmacanic'

Jul 30, 2008 | 1990 Daihatsu Charade

Not finding what you are looking for?

View Most Popular

1990 Rocky

  • Cars & Trucks

Related Question

Why does engine warning light keep coming on?

  • 2004 Daihatsu Terios

Open Questions:

0 Answers

have just changedfuel injectors and bought brand new and has gas to all injecctors but want run un less you spray strating fl in

Jul 13, 2014 | 1990 Daihatsu Rocky

0 Answers

transfer case diagrams 1982 f55 daihatsu

Jun 27, 2014 | 1990 Daihatsu Rocky

0 Answers

i need to know how to shim rear wheel bearings diahatsu 1990 rocky ute f77 model

Jun 19, 2014 | 1990 Daihatsu Rocky

0 Answers

i need to know how to shim rear wheel bearings diahatsu 1990 rocky ute f77 model

Jun 19, 2014 | 1990 Daihatsu Rocky

See all 1990 Daihatsu Rocky Questions

1990 Daihatsu Rocky Logo

Related Topics:

88 people viewed this question

Ask a Question

Usually answered in minutes!

Popular Questions

3 Answers
Where is the coolant temp

Daihatsu Rocky Cars & Trucks

2 Answers
I need a full diagram of all the vacuum hose for a daihastsu feroza 1.6l 16v

Daihatsu Rocky Cars & Trucks

1 Answer
How do i change the

Daihatsu Rocky Cars & Trucks

1 Answer
Daihatsu Feroza 1991 4x4.

1990 Daihatsu Rocky

1 Answer
Where could i locate the chassis number from

1990 Daihatsu Rocky

Check Out the Latest Top Trucks Report!
Check Out the Latest Top Trucks Report!

View all Fixya Reports

Top Daihatsu Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Muntejaya Ginting
Muntejaya Ginting

Level 3 Expert

10422 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

6523 Answers

Are you a Daihatsu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...